Filter
Top Products
User and Installation Guide
Page 8
R
Troubleshooting
Problem Possible Cause Solution
The transmit light
does not go on after
DC power is applied
to the transmitter
Faulty AC adapter
or faulty power outlet
Check the power outlet and
the AC adapter; if possible,
check for correct voltage of
the AC adapter.
No audio present at
audio input
Check the audio connection
to the transmitter and ensure
that there is audio present.
The transmit light
goes out after a few
seconds and does
not light again
Transmitter hung up Disconnect and then
reconnect DC power.
Faulty AC adapter
or faulty power outlet
See under “Faulty AC adapter
or faulty power outlet“ above.
Transmitter volume
control set too low
Adjust the transmitter volume
control.
Amplifier volume
control set too low
Adjust the amplifier volume
control.
No audio at
amplifier
Strong interference See under “Strong
Interference“ on next page.
Transmitter volume
control set too high
Adjust the transmitter volume
control until clipping stops.
Amplifier volume
control set too high
Adjust the amplifier volume
control until clipping stops.
Audio is distorted
Strong interference See under “Strong
Interference“ on next page.
Transmitter volume
control set too low
Adjust the transmitter volume
control to achieve desired
audio level.
Amplifier volume
control set too low
Adjust the amplifier volume
control to achieve desired
audio level.
Speaker audio level
is too low
Audio signal too
weak
Increase the output level of
the audio source (connect
transmitter to an adjustable
output by using an adapter if
necessary).