Filter
Top Products
Rear Panel Control
37. AC Cord - Plug this cable into a standard wall outlet. Check that the voltage
in your area matches the ampliers required voltage.
38. Channel 1 TRS Input - Channel one 1/4” female jack. Excepts either a bal-
anced or unbalanced plug. See page 9 for more details.
39. Channel 1 XLR input - Channel one 3-pin XLR balanced input jack. See
page 9 for more details.
40. Mode Switch - This switch controls the amplier’s operating mode. The
amplier can operate in three different modes; Mono Bridge, Parallel Mono, or
Stereo. The amplier is shipped in stereo mode.
41. Channel 2 XLR Input - Channel two 3-pin XLR balanced input jack. See
page 9 for more details.
42. Channel 2 TRS Input - Channel two 1/4” female jack. Excepts either a bal-
anced or unbalanced plug. See page 9 for more details.
43. Filter Switch - This switch controls the amplier’s lter mode. The amplier
can operate in three different lter modes; High Pass, Low Pass, and By-Pass.
44. Sensitivity Switch - This switch lets you choose the input sensitivity.
45. Ground On/Off Switch - If hear a hum or any interference, put the Ground
switch in the “On” postion .
46. Channel 2 Output Jack/5 way Binding Post - Connect to your speaker’s
input jack. Red is positive signal and Black is negative signal.
47. Channel 1 Output Jack/5 way Binding Post - Connect to your speaker’s
input jack. Red is positive signal and Black is negative signal.
48. Channel 1 Speakon Output - Optional speaker output connections. Use
pins 1+ and 1- of this 4-pole Speakon connector to connect to your speaker’s
Speakon input jack.
49. Channel 2 Speakon Output - Optional speaker output connections. Use
pins 1+ and 1- of this 4-pole Speakon connector to connect to your speaker’s
Speakon input jack.
50. Cooling Fans - Dual high speed cooling fans
50. Fuse Holder - This housing stores a 8 amp GMA protective fuse. Never
defeat the fuse, the fuse is designed to protect the electronics in the event of
severe power uctuations. Always be sure to replace the fuse with an exact
match as the one being replaced, unless otherwise told to do so by an autho-
rized American Audio® service technician.
37 44434241403938 4645 50494847
©American Audio® - www.americanaudio.com - VLP Series™ Power Amplifier User Manual Page 8
51
Figure 4