Filter
Top Products
AC IN-
PLAYER CONTROL
B A
OUTPUT
CH-2
CH-1
LIGHT
CONTROL
MIC
MASTER
REC
LINE2 LINE1
PHONO2
AUX2
PHONO1
AUX1
AUX2 PHONO2
AUX1 PHONO1
L
R
GND
GND
Q-D5 MKII™ Controls and Features Cont.
©American Audio® - www.AmericanAudio.us - Q-D5 MKII™ Instruction Manual Page 8
17. AC CONNECTION - This connector is used to supply main power to the unit via the included
detachable power cord. Use only the supplied, polarized AC power cord. This cord is designed to t in
one direction only. Do not attempt to force a cord in if it does not t, be sure the cord is being inserted
properly
18. AC VOLTAGE SELECTOR - This switch is used to adjust the operating voltage. Operating voltage
can be toggled between 115V/50Hz or 230V/60Hz. Always be sure the selector is set to the proper
voltage for your area before attempting to operate the unit.
19. PLAYER CONTROL - These jacks are used to control the “Q-Start” function between the mixer
and a compatible American Audio CD Player. Input mini plugs from CD player controller into these
jacks, input CD 1 into jack A and CD 2 into jack B.
20. LIGHT CONTROL - This jack provides a preset mono audio signal output. There is no way to
adjust this level, however this level will directly reect the output level of the CHANNEL FADERS (2).
This buffered audio output should only be used for light controllers that can accept an external audio
input. Great for Touch Panels and Chase Controllers.
21. DJ MICROPHONE CONNECTOR - This jack is used to a connect a microphone to the mixer.
Connect you microphone via 1/4 inch (6.3mm) jack. The signal volume will be controlled by the DJ MIC
KNOB (6a). The bass and treble levels can also be adjusted by the built-in MICROPHONE EQ (6b).
22. BALANCED XLR MASTER OUTPUTS - The Master Output includes a pair XLR Balanced
JACKS as well as a pair RCA UNBALANCED JACKS (23). The 3-pin XLR jacks send a high current
balanced output signal. These jacks should be used when you will be driving an amp or other audio
22
282726
252423
21201917
3029
18