Filter
Top Products
Rear Panel:
2. INPUT LEVEL – This knob is used to regulate the output signal of the line level source con-
nected to the Line Level Input Jacks (4 & 6).
3. FREQUENCY RESPONSE – This knob is used to adjust the crossover frequency of the sub-
woofer.
4. BALANCED XLR/1/4” LINE INPUT – This connection is designed to accept a balanced line
input signal from a mixer or other line level device with a balanced output jack. Use a balanced
cable when the signal cable length exceeds 15 feet, this will reduce excessive signal loss. Be
sure to connect only line level input devices such as mixers and tape machines to this jack.
5. XLR PARALLEL OUTPUT JACK – This jack is used to send the incoming signal from either of
the Inputs Jacks to another PSW 15P™ or
speaker.
6. BALANCED XLR/1/4” LINE INPUT – This connection is designed to accept a balanced line
input signal from a mixer or other line level device with a balanced output jack. Use a balanced
cable when the signal cable length exceeds 15 feet, this will reduce excessive signal loss. Be
sure to connect only line level input devices such as mixers and tape machines to this jack.
P
SW 15™/
P
SW 15P™ Rear Panel Controls and Features
©American Audio® - www.AmericanAudio.us - PSW 15™/PSW 15P™ - Instruction Manual Page 7
Rear of PSW 15P™
2
11
10
9
8
7
6
5
4
3