Filter
Top Products
1. Checking the Contents
Be sure your CDI-100 Mp3 was shipped with the following:
1) CDI-100 Mp3 Professional CD player.
2) Operating instructions (this booklet).
3) One (1) set of RCA cables.
4) One (1) 1/8” mini plug.
5) Warranty card.
2. Installing the Units
Place your unit on a flat surface or mount it in a flat surface case
3. Connections
1) Be sure the power is disconnected.
2) Connect the included RCA cable from your CDI-100 Mp3 outputs to the inputs on your
mixer.
3) Use the supplied 1/8” mini plug cable to connect your CDI-100 Mp3 to a mini jack
connection (A or B ) on a compatible American Audio® or American DJ® “Fader Q Start”
mixer.
CAUTION:
• Be sure to use the supplied mono 1/8" control cables. Using other types of cable may result
in unit damage
• To avoid severe damage to the unit, be sure the power is off when making connections to
the unit.
SET-UP
CAUTION:
• The player will work normally when the main unit is mounted with the front panel within 15
degrees of the vertical plane If the unit is tilted excessively, discs may not be loaded or unloaded
properly. (Figure 1)
CAUTION:
• The LCD is designed to be clearly visible within the angles shown in Figure 2. Mount the control
unit so that the visual angle is within this range.
Figure 1
15˚
Figure 2
©American Audio® - www.AmericanAudio.us - CDI-100 Mp3 Instruction Manual Page 8
50˚
10˚