Filter
Top Products
DISTRIBUTION AMPLIFIERS
5
APPLICATION DIAGRAM 5
INSTALLATION 6
Step 1. Please attach the Interface on the rack
or table using the optional hardware.
Step 2. The DA1226AT may be used with either
110V or 220V and offers a universal IEC
connector for ease of use throughout
the world. Before plugging in the power
cord to the unit, please verify that the
voltage rating of 110V/220V on the
FUSE CLIP located at the rear of the
unit is the same as the voltage rating on
the power outlet. To change setting,
unplug the power cord from the
DA1226AT and squeeze the clips on
either side of the fuse box. Then turn
the FUSE DIP 180 degrees,
repositioning it in the clip so that the
voltage is visible through the window.
Please reinsert the fuse box, and push it
in until the side clips of the fuse box
click and lock securely into place.
Step 3. Then connect the appropriate power
cord for your country into the power
input socket of the DA1226AT gently,
but firmly. The power indicator light on
the front panel of the DA1226AT should
turn on.
Step 4. Connect the video output of the source
of the (computer or other high-resolution
source) to input of the DA1226AT using
a high quality of coaxial-type cables. If
the source offers a VGA-type 15 pin HD
connector, use a HD 15 to 5-BNC made
for the MS8102CA or the MS8112CA.
NOTE: You may have to use an
interface with your source to provide the
appropriate signal format type for
DA1226AT or to use a local monitor if
needed.
Step 5. Connect the output channels of the
amplifier to the display devices
(monitors and/or projectors.) using a
good quality of coaxial cables.
Step 6. Confirm picture quality on all displays. If
you are not receiving a signal, make
sure that the display is compatible with
the resolution of the computer graphics
card. If the picture quality is less than
perfect, check to make sure that all of
your connections are solid and that you
are using a high quality cable.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls.