Altinex DA1921SX Stereo Amplifier User Manual


 
DISTRIBUTION AMPLIFIERS
400-0155-002
2
2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
DA1921SX. Keep this manual handy for future
reference. These safety instructions are to ensure
the long life of your DA1921SX and to prevent fire
and shock hazard. Please read them carefully and
heed all warnings.
1.1 GENERAL
Unauthorized personnel shall not open the unit
since there are high-voltage components inside.
Qualified ALTINEX service personnel, or
authorized representatives, must perform all
service.
1.2 GUIDELINES FOR RACK-MOUNTING
Maximum operating ambient temperature is
35 (degrees C).
When installing equipment into a rack, distribute
the units evenly. Otherwise, hazardous conditions
may be created by an uneven weight distribution.
Connect the unit to a properly rated supply
circuit.
Reliable Earth Grounding of Rack-Mounted
Equipment should be maintained.
1.3 INSTALLATION
For best results, place the DA1921SX on a flat,
level surface in a dry area away from dust and
moisture.
To prevent fire or shock, do not expose unit to
rain or moisture. Do not place the DA1921SX in
direct sunlight, near heaters or heat radiating
appliances, or near liquid. Exposure to direct
sunlight, smoke, or steam can harm components.
Handle the DA1921SX carefully. Dropping or
jarring can damage internal components.
Do not place heavy objects on the DA1921SX. If
the DA1921SX is mounted to a table or wall, use
only ALTINEX-made mounting accessories, such
as the mini-brackets MB1001 and cables for
optimum setup.
To turn off the main power, be sure to remove
the adapter from the power outlet. The power
outlet socket should be installed as near to the
equipment as possible, and should be easily
accessible.
Do not pull the adapter or any cable that is
attached to the DA1921SX.
If the DA1921SX is not used for an extended
period, disconnect the adapter from the outlet.
1.4 CLEANING
Unplug the DA1921SX (adapter or cord) before
cleaning. Clean surfaces with a dry cloth. Never
use strong detergents or solvents, such as
alcohol or thinner. Do not use a wet cloth or
water to clean the unit.
1.5 FCC / CE NOTICE
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference at
their expense.
Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could void
the user’s authority to operate the equipment.