Filter
Top Products
DISTRIBUTION AMPLIFIERS
6
INSTALLING YOUR DISTRIBUTION
AMPLIFIER 6
Step 1. Make sure that the correct power adapter
is connected to the unit. A red LED will
light to indicate that the unit is receiving
power.
Step 2. Connect the video output of the source
(computer or other high-resolution source)
to the input of the DA1902SX using a
short, high, quality coaxial-type cable. If
the source offers a VGA type 15-pin HD
connector, Altinex part # MS8102CA (6'
15-pin HD male to 5 BNC male) may be
used.
Step 3. Connect monitors or projectors to the
outputs of the DA1902SX using the
appropriate VGA type cables or adapter
cables. If the DA1902SX were being used
in the Serial Distribution System, the
outputs of the DA1902SX would typically
be connected to the units of the
DA1904SX by using VGA type cables
(Altinex CB3700 Series Cables).
Step 4. If the DA1902SX is being used in the
Serial Distribution System, make sure that
the end of the video bus is properly
terminated with a monitor or with a
termination plug. This would usually be
done on the loop end of the DA1904SX.
Step 5. Verify that the quality of the picture on all
displays is perfect. If you are not
receiving a signal, make sure that the
display is compatible with the resolution of
the computer graphics card.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls.