Filter
Top Products
ALPINE TDM-9501RM 68P01434K82-O
21-EN
Installation
1 Remove the Detachable Front Panel (refer to
page 4). Slide mounting sleeve from main unit.
(See Removal Procedure) Slide the mounting
sleeve into the dashboard.
2 When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the TDM-
9505RB/TDM-9503R/TDM-9501RM/TDM-9501R
and put the Rubber Cap on the hex bolt. If your
vehicle does not have the Mounting Support,
reinforce the head unit with the metal mounting
strap (not supplied). Connect all the leads of the
TDM-9505RB/TDM-9503R/TDM-9501RM/TDM-
9501R according to details described in the
CONNECTIONS section.
NOTE:
For the screw *, provide a proper screw to the chassis
installing location.
3 Slide the TDM-9505RB/TDM-9503R/TDM-
9501RM/TDM-9501R into the dashboard. When
the unit is in place, make sure the locking pins
are fully seated in the down position. This can be
done by pressing firmly in on the unit while
pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly
locked and will not accidentally come out from
the dashboard. Install the Detachable Front
Panel.
Lock pin
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Face Plate
Mounting Bracket
Metal Mounting Strap
Screw
Bolt Stud
Hex Nut
(M5)
∗
Bracket
Mounting Sleeve
(Included)
TDM-9505RB/TDM-9503R/
TDM-9501RM/TDM-9501R
Dashboard
Rubber Cap
(Included)
Hex Bolt
(Included)
TDM-9505RB/TDM-9503R/
TDM-9501RM/TDM-9501R
Screws (M5 × 8)
(Included)
TDM-9505RB/TDM-9503R/
TDM-9501RM/TDM-9501R
7/20-24 (EN) TDM-9505RB 02.6.29, 9:23 AM21