Filter
Top Products
9-EN
Basic
Sound (Beep) Guide Function
This function will give audible feedback with
varying tones depending upon the button pressed.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the f UP button repeatedly to select
"BEEP."
Each press of the f UP button changes the
modes as shown:
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
∗ CDA-7873R/TDA-7587R Only
3 Press the TUNE button to toggle the mode
between "BEEP ON" and "BEEP OFF."
NOTE
The initial setting at the factory is BEEP ON.
4 Press the SETUP button to set the selected
mode.
Turning Mute Mode On/Off
If a device having the interrupt feature is
connected, audio will be automatically muted
whenever the interrupt signal is received from the
device. This function can be turned ON or OFF
from the head unit by following procedure below.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the f UP button to select the "MUTE"
mode. Each press changes the modes as shown:
∗ CDA-7873R/TDA-7587R Only
NOTE
If you press the g DN button the display scrolls in
reverse sequence.
3 Press the TUNE button to turn on or off the Mute
mode.
Each press toggles between the "MUTE ON"
and "MUTE OFF" modes.
NOTE
The initial setting at the factory is "MUTE ON."
4 Press the SETUP button again to return to
normal operation.
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
∗
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←
→ FM-LV → REG → PTY31 → HI-FI/NORMAL/STABLE → AMBER
∗
DEMO ← AUX ← SCR ← MUTE ← BEEP ← SUB ← DIM ←