Filter
Top Products
FR
ES
DE
SE
IT
5-EN
Turning Power On and Off
1 Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button
except the eject c button.
The volume level gradually increases to the
previous level you were listening to before the
unit was turned off.
Press and hold the POWER button again for at
least 3 seconds.
NOTE
The very first time the power is turned on, the volume
will start from level 12, and the LOUD function will be
on in the tuner mode.
Subwoofer On and Off
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select
the SUB-W mode.
3 Press the BAND button to select Subwoofer ON
or OFF.
4 After setting is completed, press the SETUP
button to return to normal mode.
NOTES
• Initial mode is "Subwoofer ON."
• Set to "Subwoofer OFF" unless the subwoofer is
used.
• When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer
to the Adjusting Volume/Balance/Fader.
Adjusting Volume/Balance
(Between Left and Right)/Fader
(Between Front and Rear)
1 Press the MODE button repeatedly to choose
the desired mode.
Each press changes the modes as follows:
NOTE
If the 5 or 6 button is not pressed in 5 seconds after
selecting the BALANCE and FADER modes, the unit
automatically sets in the VOLUME mode.
2 Press the 5 and 6 buttons until the desired
sound is obtained in each mode.
Turning Loudness On/Off
Loudness introduces a special low- and high-
frequency emphasis at low listening levels. This
compensates for the ear's decreased sensitivity
to bass and treble sound.
1 Press and hold the LOUD button for at least
2 seconds to activate or deactivate the loudness
mode. The display shows "LOUD ON" when the
loudness mode is activated.
Adjusting Source Signal Levels
If the difference in volume level between the CD
player and FM radio is too great, adjust the FM
signal level as follows.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select
the FM LV (FM LEVEL) mode.
3 Press the BAND button to select the FM signal
level HI (High) or LO (Low) to make the signal
levels between the FM band and CD player
closer.
4 Press the SETUP button to return to normal
mode.
→ VOL → BAL → FAD