Filter
Top Products
7-EN
01GB04CDE9881.fm
ALPINE CDE-9881 68-08564Z04-A (EN)
Adjusting Volume
Turn the Rotary encoder until the desired sound is
obtained.
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press (MUTE) to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing (MUTE) again will bring the audio back to
its previous level.
Setting Time
1
Press SETUP to activate the SETUP mode.
2
Turn the Rotary encoder to select the CLOCK
ADJUST mode, and then press / /ENT.
The time indication will blink.
3
Turn the Rotary encoder to adjust the hours while
the time indication is blinking.
4
When the hour has been adjusted, press / /ENT.
5
Turn the Rotary encoder to adjust the minutes
while the time indication is blinking.
6
Press SETUP to return to normal mode.
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold //ENT for at least 2 seconds
after setting the “hour.” Minutes will reset to “00”. If the display
shows over “30” minutes when you do this, the time will advance one
hour.
• Pressing RTN will return to the previous mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Listening to Radio
1
Press SOURCE/ to select TUNER mode.
2
Press BAND repeatedly until the desired radio band
is displayed.
F1 (FM1) F2 (FM2) AM F1 (FM1)
3
Press TUNE/A.ME to select the tuning mode.
DX SEEK (Distance mode) SEEK (Local mode)
OFF (Manual mode) DX SEEK
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or will change the frequency
continuously.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote
control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote
control sensor.
Remote control sensor
Radio
BAND
Preset buttons
(1 through 6)
TUNE/A.ME
SOURCE/
01GB00CDE9881.book Page 7 Friday, September 22, 2006 3:34 PM