Filter
Top Products
8
I
N
S
T
A
L
L
A
T
I
O
N
C
O
N
T
I
N
U
E
D
Once you have tested your system and have confirmed that it
is operating properly, turn off your system and prepare for the
final mounting of the speakers.
1. Position the speaker into the mounting hole and
reconfirm the correct mounting location and hole placement.
Screw clips are provided to insure a snug fit. Place screw clips
over the metal surface and line up the hole with the hole you
have previously drilled. Place the speaker into the hole, align the
mounting holes and proceed to insert the screws. Be sure to
tighten the screws evenly as to not warp the speaker frame.
2. Turn your system back on and confirm the speaker's
operation, first at low volume and then you may increase the
volume as you desire.
3. The next steps will aid in the proper mounting of the
speaker grilles. Follow these steps carefully and be patient.
First, locate the special bonding rubber which is located between
the waxed paper in the hardware package.
4. Carefully inspect the mounting ring where the grill
will be inserted. You will notice 4 to 6 channeled areas. This is
the area where the bonding rubber will secure the grill to the
speaker.
5. Break off pieces of the bonding rubber that correspond
to the size of the channels and insert it snugly in place. Once all
of the channels have been filled, carefully insert the grille and
press it firmly into place.