Filter
Top Products
5
F
E
A
T
U
R
E
S
A
N
D
S
P
E
C
I
F
I
C
A
T
I
O
N
S
CROSSOVER CONTROL
It is recommended that the MID BASS / MID / HI frequencies be set at
center position and that the SUB frequency set at around 60Hz. One
of the best features of this unit is that it allows the listener to adjust
each band exactly to his/her own satisfaction. PLEASE NOTE: That
the correct settings depend very much on the overall system itself and
the individual musical taste of the listener. Please check the settings
for each band carefully before completing the installation.
SET-UP ADJUSTMENT
Before Turning On: Turn the unit volume to minimum, adjust the input
gains to minimum, Turn the source unit volume to minimum, Set EQ
controls to at (12 o’clock).
System Turn On: After completing all wiring and signal connections
you can now turn the system on.
Adjust: Raise volume of the unit to maximum. Adjust left and right
input gains of the unit until half way between minimum and maximum.
Gradually increase source volume until clipping occurs. Begin gradual-
ly increasing input gains until distortion is audible, then reduce slightly,
system should be extremely loud at this point. Turn the volume control
down to minimum and back up to comfortable level.