Aiwa XP-ER800N CD Player User Manual


  Open as PDF
of 2
 
WARNING
To prevent fire or shock hazard, do not expose the unit to
rain or moisture.
Do not install the appliance in a confined space, such as
a bookcase or built-in cabinet.
To prevent fire, do not cover the ventilation of the
apparatus with newspapers, tablecloths, curtains, etc. And
don’t place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place objects filled
with liquids, such as vases, on the apparatus.
CAUTION
The use of optical instruments with this product will
increase eye hazard.
Certain countries may regulate disposal of the battery used
to power this product. Please consult with your local
authority.
CAUTION
• INVISIBLE LASER RADIATION WHEN OPEN
• DO NOT STARE INTO BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENT
The validity of the CE marking is restricted to only those
countries where it is legally enforced, mainly in the
countries EEA (European Economic Area).
Owner’s Record
The model number and the serial number are located at the
rear of the CD player. Record the serial number in the
space provided below. Refer to these numbers whenever
you call upon your Aiwa dealer regarding this product.
Model No. XP-ER800N
Serial No.
For the customers in the USA
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
–
Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
Declaration of Conformity
Trade Name: AIWA
Model No.: XP-ER800N
Responsible Party: Sony Electronics Inc.
Address: 680 Kinderkamack Road,
Oradell, NJ 07649
USA
Telephone No.: 201-930-6973
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Power Sources
To use the batteries (B)
Use only the following batteries for your CD player:
Dry batteries
• LR6 (size AA) alkaline batteries (not supplied)
Rechargeable batteries
Charge the rechargeable batteries before using them for
the first time.
• Commercially-available size AA Ni-MH rechargeable
batteries of 1.2 V DC, 700 mAh
To insert the batteries
1
Open the battery compartment lid on the rear of your CD
player.
2 Insert two batteries by matching the ) to the diagram
in the battery compartment and close the lid until it
clicks into place.
3 When using the rechargeable batteries, connect the
commercially-available AC power adaptor to the DC
IN 4.5V jack of your CD player and an AC outlet,
then press s/OFF/CHARGE while the CD player is
turned off to start charging.
The CD player charges the batteries. The “CHG”
indicator turns on in the display and the the indicator
sections of
light up in succession. When the
batteries are completely charged, the “CHG” and
indicators get turned off.
If you press s/OFF/CHARGE after the charge has
already been completed, the
indicator flashes
and “Full” appears in the display.
4 Disconnect the AC power adaptor.
D
Label side up
C
3-252-981-21 (1)
CD player (front)
to an AC outlet
\
DC IN 4.5 V
(external power
input) jack
Insert the ( end first (for both batteries).
AC power
adaptor
B
Headphones
Open the battery compartment lid.
*The button has a tactile dot.
Strap holes
4SOUND
Display
8r/t
SKIP/SEARCH
0MODE
DC IN
4.5V
\ (headphones)
jack
!HOLD
@VOL +*/–
9ca*
567 s(stop)/OFF/CHARGE
Display
3BAND
Battery life* (approx. hours)
(When the CD player is used on a flat and stable place.)
Playing time varies depending on how the CD player is used.
E•A•S•S E•A•S•S Radio
ON
Two Sony alkaline 38 32 58
batteries LR6 (SG)
(produced in Japan)
* Measured value by the standard of JEITA (Japan
Electronics and Information Technology Industries
Association).
To check the remaining power of the
batteries
You can check it in the display.
Replace the batteries when “
” flashes.
Lo batt*
* Beep sounds.
Notes
• The indicator sections of roughly shows the
remaining battery power. One section does not always
indicate one-fourth of the battery power.
• Depending on operating conditions, the indicator
sections of
may increase or decrease.
Notes on using the dry batteries
• Be sure to remove the AC power adaptor.
• When the batteries are depleted, replace both batteries
with new ones.
Notes on the rechargeable batteries
• To keep the original battery capacity for a long time,
charge the batteries only when they are completely
depleted.
• If the battery is new or has not been used for a long
time, it may not be charged completely until you charge
and discharge it several times.
• When carrying the rechargeable batteries, use the
battery carrying case supplied with the rechargeable
batteries to prevent unexpected heat. If the rechargeable
batteries and the metallic objects get contacted, heat or
fire may occur due to a short circuit.
When to replace the rechargeable
batteries
If the battery life becomes shorter by about half, replace
the batteries with new rechargeable batteries.
To use the AC power adaptor (C)
1 Connect the commercially-available AC power
adaptor whose rated output is 4.5 V DC, 500 mA, to
an AC outlet.
Playing a CD
To insert a CD
1 Slide OPEN to open the lid (A).
2 Fit the CD to the pivot, then close the lid (D).
Notes
• This CD player can play discs recorded in the Compact
Disc Digital Audio (Audio CD) format.
• This CD player can play CD-Rs/CD-RWs recorded in
the Compact Disc Digital Audio (Audio CD) format,
but playback capability may vary depending on the
quality of the disc and the condition of the recording
device.
• This product is designed to play back discs that conform
to the Compact Disc (CD) standard.
Recently, various music discs encoded with copyright
protection technologies are marketed by some record
companies. Please be aware that among those discs,
there are some that do not conform to the CD standard
and may not be playable by this product.
To operate the CD player
Button/Switch and its Function/Operation
1 ENTER/DISPLAY
Press to check the remaining time on the CD and the
number of tracks left. Also press to enter the selected
track for the PGM play.
2 PRESET CALL UP/DOWN
Press to select the preset station you want.
3 BAND
Press to turn on the radio. Press also to change the
band.
4 SOUND
Use to emphasize the bass-boosted sound. Press
repeatedly to select
or .
enhances more than .*
5 s(stop)
Press to stop playing.
6 OFF
Press to turn off the radio.
7 CHARGE
Press to start charging.
8 r/t (skip/search)
For CD player: Press r or t once to find the
beginning of the current/next track.
Press r or t repeatedly to find the beginning
of the previous/ succeeding tracks.
Press and hold r or t to go backward/forward
quickly.
For radio: Press to tune in the station you want.
9 ca (play/pause)
Press to start play. Press again to pause play.
To play from the first track, press for 2 seconds or
more while the CD player is stopped.
Button/Switch and its Function/Operation
0 MODE
For CD player: Press repeatedly until the play mode
you want appears in the display.
No indication: Normal play
“1”: Single play
“SHUF”: Shuffle play
“PGM”: PGM (program) play
To repeat the play mode you selected, press and hold
until “
” appears.
For radio: Press until “ST” disappears from the
display to improve the receiving condition on FM.
! HOLD
Use to lock the controls to prevent accidental button
presses.
@ VOL+/–
Press to adjust the volume.
* If the sound is distorted when using the SOUND function,
turn down the volume.
To protect against sound skipping
The E•A•S•S function has been developed to provide
excellent protection against sound skipping during many
active uses.
1 Insert a disc and wait until the display goes off.
2 While holding MODE, press ca.
3 Press MODE to select the E•A•S•S mode.
When you select “E•A•S•S”, the E•A•S•S function is
enhanced compared to “E•A•S•S
”.
To walk with the CD player and enjoy high quality
CD sound using the E•A•S•S function, select
“E•A•S•S
”. While taking harder exercises, it is
recommended that you set it to “E•A•S•S.”
4 Press ENTER/DISPLAY.
Note
Sound may skip:
– if the CD player receives stronger continuous shock than
expected,
– if a dirty or scratched CD is played or
– when using poor-quality CD-Rs/CD-RWs or if there is a
problem with the recording device or application software.
Checking the remaining time on the CD
and the number of tracks left
You can check the remaining time on the CD and the
number of racks left using ENTER/DISPLAY.
1 Press ENTER/DISPLAY.
Each time you press the button, the display changes as
follows:
Display
Normal play Track number and
elapsed playing time
Press ENTER/DISPLAY once.
Track number and
remaining time on the
current track.
Press ENTER/DISPLAY once again.
The number of tracks left
and remaining time on
the CD*
*Not displayed during the Single play and Shuffle play.
To remove the CD
Remove the CD while pressing the pivot.
To turn off the operation beep
sound
You can turn off the beep sound that is heard from your
headphones when you operate your CD player.
1 Remove the power source (AC power adaptor, dry
batteries) from the CD player, and wait for about 3
seconds.
2 Connect the power source while pressing s/OFF/
CHARGE.
To turn on the beep sound
Remove the power source, wait for about 3 seconds, and
then connect the power source without pressing s/OFF/
CHARGE.
Playing tracks in your
favorite order (PGM play)
You can program the CD player to play up to 24 tracks in
your favorite order.
1 During playback, press MODE repeatedly until
“PGM” flashes.
2 Press r or t to select a track.
3 Press ENTER/DISPLAY to enter the selected track.
“00” appears and the playing order increases
by one.
4 Repeat steps 2 and 3 to select the tracks in your
favorite order.
5 Press and hold ENTER/DISPLAY until the PGM play
starts.
2PRESET CALL UP/DOWN
1ENTER/DISPLAY
A
OPEN
TV/WB/FM/AM
Portable CD Player
Operating Instructions
XP-ER800N
Sony Corporation ©2003 Printed in China
http://www.aiwa.com/
To check the program
During programming, press ENTER/DISPLAY repeatedly
before step 5. Each time you press ENTER/DISPLAY, the
track number appears.
Note
• When you finish entering the 24th track in step 3, the
first selected track appears in the display.
• During the PGM play, you cannot check the program.
To cancel PGM play
During programming or PGM play, press MODE once so
that “PGM” disappears.
(Continue to the reverse side)
Play mode
Track number/PRESET number
Sound mode
Playing time/
Frequency
PRESET
E•A•S•S
Remaining
battery power
BandST
VOL CHG