Filter
Top Products
16
ENGLISH
TO LISTEN TO THE ORIGINAL DTS
SOUND
When “dts” appears on the display, all the sound settings can be
canceled.
Preparation
Play a disc recorded in DTS surround.
1 Press ENTER.
“BY-PASS OFF” is displayed.
2Press ENTER again so that “BY-PASS ON” is
displayed.
To restore the sound settings
Repeat steps 1 and 2 so that “BY-PASS OFF” appears.
To operate with the remote control
Hold down SHIFT and press MID NIGHT repeatedly.
OTHER SETTINGS
JOG +,-
MID NIGHT
ENTER
MULTI JOG
SHIFT
MANUAL
SELECT
ADJUSTING LOW FREQUENCY SOUND
EFFECT (LFE)
The disc recorded in Dolby Digital surround contains special
signals called LFE to enhance low frequency sound effect.
The LFE signals are recorded in some particular parts on the
disc and output from the connected sub woofer to reproduce
astonishingly powerful low sound.
The sound level of the LFE signals can be adjusted according to
your speakers.
Preparation
Play a disc recorded in Dolby Digital surround.
1 Press MANUAL SELECT on the remote control.
“LFE” is displayed.
2 Press JOG + or - to adjust the LFE level.
The unit is initially set to 0 dB (maximum) and can be adjusted
as follows:
OFF –10 dB –5 dB 0 dB
MULTI JOG on the unit is also available.
When selecting “SUBW OFF”, the LFE signals are redistributed to
other speakers.
ADJUSTING DYNAMIC RANGE
Dynamic range of the sound can be adjusted. The unit is initially
set to “STD” (standard) mode.
Preparation
Play a disc recorded in Dolby Digital surround.
1 Hold down ENTER (hold down SHIFT and press
MID NIGHT).
“MID NIGHT THEATER” runs through on the display.
2Turn MULTI JOG (press JOG + or -) to select
“MIN”, “MAX” or “STD”.
MIN: You can enjoy the full dynamic range of sound like in the
movie theater.
STD: Original position, when playing back in home, that is
recommended by the software producers.
MAX: Select this mode when playing back at low volume.