Filter
Top Products
3
6
2,4
P
1 I
1 “[-----i‘
A
—1,2,3,4
?
\-——..
9
.——-
1
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
Use the
remote control.
1
2
3
Press TIMER to display 0, then press II SET
within 6 seconds.
O
is displayed and the hour flashes.
m
If you press II SET after 6 seconds, another operation may
start.
Designate the hour of the timer-on time by
pressing <
DOWN or > UP, then press II
SET.
Repeat to designate the minute of the timer-on
time.
After you designate the timer-on time, one of the source names
flashes on the display.
Press FUNCTION to select a source, then press
II SET.
● If TUNER is pressed, the band cannot be selected in this
step.
4
5
6
Select the duration for the timer-activated periold
f
with 4 DOWN or - UP, then press [I set. ~
The duration for the timer-activated period can beset between
.g-
5 and 240 minutes in 5-minute steps.
Prepare the source.
G
To listen to a CD, load the disc to be played first on tray 1.
To
listen to a tarJe, insert the tape into deck 1 or 2.
To
listen to the radio, tune in to a station.
Press POWER to turn the unit off after adjusting
the volume and tone.
O
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 16 when the power is
turned off with the volume level set to 17 or more,
To check the specified time and source
Press TIMER. The timer-on time, the selected source name and
the duration for the timer-activated period are displayed for 4
seconds.
To cancel timer standby mode temporarily
Press TIMER re~eatedlv until ~ disaDDears on the dlSDlaV.
❑
To restore the timer standby mode, press TIMER once’ortwice
to display 0.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
● Timer playback and timer recording will not begin unless thle
power is turned off.
● Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
* MULTI JOG is also available instead of 4 and >.
Timer recording is applicable for TUNER and VIDEO/AUX (wi’!h
an external timer) sources only.
Press TIMER repeatedly until @ flashes on the display, them
press II SET within 6 seconds.
Carry out the steps of
“SETTING THE TIMER” from step 2 and insert the tape to be
recorded on into deck 2 after step 5.
ENGLISH16