Filter
Top Products
TAPE/
POWER/
6STANDBY
RADIO/BAND
\
A
SKIP/SEARCH
DOWN
– TUNING –
UP
PLAY
/PAUSE/
PRESET
STOP/
MEMORY
FM MODE/
OSC
REPEAT/
SLEEP
4 ENGLISH
1 Press *RADIO/BAND repeatedly to select
the desired band.
FM AM
The power is turned on and the previously tuned
station is received.
* or BAND on the remote control when the AC
cord is connected (CSD-TD66 only)
2 Press r, t (TUNING DOWN, UP) to
select a station.
During FM stereo reception, is displayed.
After listening, press TAPE/POWER/6STANDBY to
turn the power off.
For better reception
For quick tuning (Auto Search)
Keep r, t pressed until the tuner starts
searching for a station. When a station is tuned to, the
search stops.
If the broadcast signal is weak, it does not stop. To
stop the search manually, press r or t.
TUNER OPERATION
A
*FM MODE/OSC
- If an FM stereo broadcast contains noise, press the
button so that is displayed.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again.
- If a high-pitched sound is heard during AM recording,
press the button repeatedly until the noise is reduced.
Its position can be checked by “•” being on or off the
display.
* or MODE on the remote control (CSD-TD66 only)
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/
step. If you use this unit in an area where the frequency
allocation system is 9 kHz/step, change the interval as
follows.
1 Press RADIO/BAND to display FM.
2 Press s while pressing RADIO/BAND to display the
AM frequency.
When the AM tuning interval is changed, the preset
stations are cleared.
NOTE
If the unit picks up noise from other electrical
appliances nearby, like a TV or fluorescent lights, move
the unit away.
To listen with the headphones
Connect headphones with a stereo mini plug to the \
jack on the rear of the unit.
Extend the rod antenna
and orient it for the best
reception.
The antenna is inside the
unit. Position the unit for
the best reception.
AMFM