Filter
Top Products
REPEAT/
FM MODE/
Osc
-
STOPIMEMORY~
@@
– TUNING+
POWER(!)STANDBY
BAND
TAPE
H ““’0 I-kL.J
~ Press *RADIO/BAND repeatedly to select the
desired band.
~FM--+AMT
NOTE
If the
unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent lights, move the unit.
The power is turned on and the previously tuned
station is received.
The RADIO indicator lights up.
* or BAND on the remote control when the AC cord is
connected (except CSD-ED37)
z Press 1+4, BI (+, – TUNING) to select a
station.
During FM stereo reception, ~ is displayed.
After listening, press POWER (!) STANDBY to turn the
power off.
For better reception
$% P
Extend the FM antenna and
The AM antenna is inside
orient it for the best reception.
the unit. Position the unit
for the best reception.
For quick tuning
Keep i-,
– TUNING pressed until the tuner starts
searching for a station. When a station is tuned to, the
search stops.
If the broadcast signal is weak, it does not stop. To stop
the search manually, press -1- or –.
*REPEAT/FM MODE/OSC
- If an FM stereo broadcast contains noise, press the
button so that _ is displayed.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again.
- If a high-pitched sound is heard during
AM recording,
press the button repeatedly until the noise is reduced. Its
position can be checked by “*” being
on or off the display.
* or MODE on the remote control (except CSD-ED37)
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step.
If you use this unit in an area where the frequency
allocation system is 9 kHz/step, change the interval as
follows.
1 Press RADIO/BAND to display FM.
2 Press
■ while pressing RADIO/BAND to display the
AM frequency.
When the AM tuning interval is changed, the preset
stations are cleared.
You can preset up to 15 stations in each band.
Select a station.
Press *9 STOP/MEMORY once so that “M” is
displayed to store the station.
A station is assigned a preset number, beginning from 1
in consecutive order for each band.
“M” may not be displayed if the button is kept pressed for
more than 0.5 second.
Preset number
Frequency
* or
■ on the remote control (except CSD-ED37)
B
Repeat steps 1 and 2.
The next station will not be stored if a total of 15 preset
stations have already been stored for a band.
TO listen to preset stations
Select a band then press -11 PLAY/PAUSE/PRESET
repeatedly.
- PLAY on the remote control is also available.
To select a preset number directly with the remote
control (except CSD-ED37)
Press the numbered buttons O-9 and +1 O.
Example:
To select number 15, press +10 and 5.
To select number 10, press +10 and O.
To clear a preset station
Display the preset number first. Then, press
■ while the
preset number is displayed.
The higher numbers in the band are decreased by one,
4 ENGLISH