Aiwa CX-NA303 Speaker System User Manual


 
This section explains how to record from the tuner, CD player, or
external equipment.
2
t+
- —,_,,,,,,,,.
Preparation
Use Type I (normal) tapes only.
Set the tape to the point where recording will start.
Note that recording is done on only one side of the tape.
1
2
3
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
A EJECT
I
1
J
Press function (CD, TUNER or VIDEO/AUX) and
prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from
a connected source, press VIDEO/AUX and
play.
Press REC/REC MUTE to start recording.
When the selected function is CD, playback and re=ording
start simultaneously.
To stop recording, press
.
To
psuse recording, press II. (Applicable when the source is
TUNER or VIDEO/AUX) To resume recording, press it again.
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting of the recording.
~*.;a.,mm,d*mx,r*cm%@’*w XF%.=kee.,, *W. .
,.
*m,,=a,$ ~~ax=.~~ *g,*>q,$~~r4.J,* wLw$,,”%, .,*,W $3$%W%W-W$
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER,
VIDEO/AUX or MD.)
1 Press REC/REC MUTE during recording or while in
recording pause mode.
~
on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2
Press II to reeume recording.
To insert a blank space of less than 4 seconds,
press
REC/REC MUTE again while ~ is flashing.
To insert blank
spacee of more than 4 seconds, afterthe deck
enters recording pause mode, press
REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is added.
>
About cassette tapes
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
To record on the tape again, cover the tab openings with
adhesive tape, etc.
120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
To erase a recording
1
Insert the tape to be erased into deck 2 and press TAPE/
DECK 1/2
to display “TP 2.
2 Set the tape to the point where the erasure is to be started.
3 Press
REC/REC MUTE to start the erasure.
I I ENGLISH