Filter
Top Products
En
ENGLISH
11
BASIC OPERATIONS
RECORDING AN AUDIO SOURCE
FUNCTION
FUNCTION
INPUT MODE
1 Select the program source to be recorded.
Turn FUNCTION (or press FUNCTION repeatedly).
2 Set the tape deck or MD recorder to recording
mode.
3Start the selected program source.
NOTE
• Any sound control system has no ef fect on recording (see page
9).
• Input sound through the DIGIT AL IN terminals cannot be
recorded. When recording the sound from the DVD, CD, MD or
LD player , connect the analog AUDIO OUT terminals of the
player to the corresponding AUDIO IN terminals of the receiver .
The sound will be recorded in 2 ch stereo.
• Input sound from the tape deck connected to the TAPE IN
terminals cannot be recorded.
WHEN THE “OVER LEVEL” INDICATOR
LIGHTS UP
When input analog signals from the connected equipment are
too high to accept, the OVER LEVEL indicator lights up. In this
case, adjust the input level so that the indicator disappears.
To lower the sound level of the connected source
When the analog sound level of the connected source is higher
than that of the FM and AM functions, adjust it as follows.
1 Select the function to be adjusted.
Turn FUNCTION and play the source.
2 Press TUNING
MM
MM
M repeatedly.
The level is decreased as follows.
0 dB –6 dB –12 dB
To restore the previous level, press TUNING N repeatedly .
•When the analog output of the CD player or DVD player is 2
Vrms, set the level to –6 dB.