Filter
Top Products
SELECTION OF AUDIO/VIDEO
SOURCE
1
1 Select the program source.
Press one of the function buttons or the TAPE MONITOR
button.
To change a displayed name for the VIDEO 1/5.1 CH
button and VIDEO 2 button
When the VIDEO 1/5.1 CH button is pressed, VIDEO 1 is
displayed initially. It can be changed to DVD or MD.
With the power on, press the POWER button while pressing the
VIDEO 1/5.1 CH button.
This VIDEO 1/5.1 CH button also works as the 5.1 CH (5.1
INPUT) function switch. While the selected function name
(VIDEO 1, DVD or MD) for the VIDEO 1/5.1 CH button is
displayed, press the button again. The function name will change
to “5.1 CH” and the source connected to the 5.1 INPUT terminals
is selected.
To resume, press the button again so that the selected function
name is displayed.
The displayed name for VIDEO 2 button can be changed to
VIDEO 2, LD orTV with the power on, press the POWER button
while pressing the VIDEO 2 button.
To adjust the sound level of the connected source
The input sensitivity level of each function (except the TUNER
and 5.1 CH functions) can be adjusted.
When the sound level of the connected source is higher or lower
than that of the TUNER, adjust it as follows.
1 Select the function to be adjusted.
Press the function button accordingly and play the source.
Television, etc.
I AUX
Com~act disc
I CD
2 Press the UPA or DOWNV button repeatedly.
Video
VIDEO 1/5.1 CH, VIDEO 2,
VIDEO 3
I
LD or Cable TV
VIDEO 2
MD or DVD
VIDEO 1/5.1 CH
The function buttons to be pressed (except PHONO) depend
on the equipment connected to the input terminals on the
rear panel of the unit.
When using a turntable with a built-in equalizer amplifier, set the
switch of the equalizer amplifier to off. See the instructions of
the turntable for further information.
2 Start the selected program source.
3 Adjust the sound.
About the video source to the monitor or TV
Selected
VIDEO source
Vl: VIDEO 1, V2: VIDEO 2, V3: VIDEO 3
The level can be adjusted between -6dB (MIN) and +f3dB (MAX)
in 2dB steps. Adjust the level so that the sound is output at the
same level as the TUNER.
● The input sensitivity level of the TUNER or 5.1 CH function
cannot be adjusted.
● That of the TAPE MONITOR cannot be adjusted either.
Even if the TAPE MONITOR is selected and the TAPE
MONITOR indicator turns red, pressing the UPA or DOWNV
button will change the level of the function displayed on the
window.
The selected video source is indicated on the display and the
video signal through the MONITOR VIDEO OUT jack is output
on the TV.
9 ENGLISH