Filter
Top Products
at the end of the track to select the other lay mode, the unit may not change to the
other mode properly.
CONNECTING TO AN EXTERNAL UNIT → M
Use a commercially available connection cord which has a 3.5 ø stereo mini-plug
at one end and two phono plugs at the other end.
Connect the stereo mini-plug to the PHONES/LINE OUT jack of the unit and connect
the phono plugs to the analog input terminals of the external unit, such as the
amplifier or the equipment with the built-in amplifier. The CD sound can be heard
through the connected audio system.
Note
• Turn off the power of both units before connection.
• DO NOT connect to the PHONO inputs of an amplifier (with a built-in
phonoequalizer-amplifier).
• Adjust the volume and DSL on this unit.
MAINTENANCE
To clean the lens → N
If the lens becomes dirty, the player will skip or not play. If this occurs, clean the
lens in the following manner.
To remove dust or dry particles, first use a camera lens blower/brush a to blow a
few times to loosen particles, then gently brush the lens b clean. Finish by blowing
the lens again.
To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe
gently from the center to the edge. Lens cleaning solution is commercially available.
Note
• Take care not to get too much solution on the swab, which could flow into the unit
and cause damage.
• Pressing too strongly with the swab could scratch or break the lens.
To clean the discs → O
Before playing, wipe the disc from the center outward with a cleaning cloth. After
playing, store the disc in its case.
SPECIFICATIONS
Tracking system 3-beam laser
Laser pickup Semiconductor laser
D/A conversion 8-times oversampling digital filter + 1-bit DAC
Frequency response 20 – 20,000 Hz (47 k ohms)
Output PHONES/LINE OUT jack (stereo mini-jack)
Maximum output 12 mW + 12 mW (16 ohms at 1 kHz)
500 mV (47 k ohms at 1 kHz)
Power supply DC 3 V using two size AA (LR6) alkaline batteries
DC 2.4 V using commercially available rechargeable
batteries
AC house current using the supplied AC adaptor
Maximum outside dimensions
134 (W) × 30 (H) × 140 (D) mm
(excluding projecting parts and controls)
(5
3
/8 × 1
3
/16 × 5
5
/8 in.)
Weight Approx. 277 g (9.7 oz.) excluding batteries
Accessories AC adaptor AC-D603 (1)
Stereo headphones (1)
Carrying case (XP-SP921 only) (1)
AC adaptor AC-D603 Rated input: AC 120 V, 60 Hz
The specifications and external appearance of this unit are subject to change
without notice.
ATTENTION:
The product you have purchased can be powered by
nickel cadmium batteries which are recyclable. At the
end of their useful life, under various state and local
laws, it is illegal to dispose of these batteries into
your municipal waste stream.
Please call 1-800-289-2492 for information on how
to recycle these batteries.
M
N
O