Filter
Top Products
{:
QSOUND
BASS
VOLUME
1
2
3
4
Set FUNCTION to CD.
Press CD OPEN to open the disc
compartment and place
a disc with the
printed side down on the disc compartment
lid.
NOTE - Do not place smaller than 3-inch (8 cm) discs.
CD
OPEN
The total number of tracks is displayed.
“1” indicates the 1st track, and “* 1” indicates the 11th
track. ‘H” and a flashing
“=” indicate the 21st , 31st .
91st track.
Press ➤1I PLAY/PAUSE to start play.
The number of the track being played is displayed.
Turn VOLUME and BASS to adjust the sound.
■
STOP – Stops play.
➤11 PLAY/PAUSE –-Pauses play. To resume play, press
again.
M,- SKIP/SEARCH – Searches for a particular point
during playback. Keep 144 or M pressed and then
release it.
– Skips to the beginning of a track. Press l++ or W
repeatedly.
REPEAT – Repeats a single track or all tracks. Select as
follows.
The REPEAT indicator flashes: A single track is played
repeatedly. Select a track with K or M.
The REPEAT indicator lights up: All tracks are played
repeatedly.
NOTE
● Do not use irregular shape CDs (example: heart-shaped,
octagonal ones).
It may result in malfunctions.
● Do not place more than one disc in the disc
compartment.
● Do not try to open the disc compartment during play.
● Do not touch the lens. Doing so may cause malfunctions.
f Set FUNCTION to RADIO.
2 Select a band with BAND.
3 Tune to a station with TUNING.
~ Turn VOLUME and BASS to adjust the sound.
For better reception
6. ‘F
Extend the FM antenna and
The AM antenna is inside
orient itfor the best reception.
the unit. Position the unit
FM MODE/OSC Rear
for the best reception.
FM MODE/OSC
-
Sets the FM sound to stereo or monaural.
STEREO: Reception is stereo.
MONO: When an FM stereo broadcast contains noise, set
to MONO. Noise is reduced, although reception is
monaural.
- If a high-pitched sound is heard during recording from
AM, set this switch to another position.
NOTE
If the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent lights, move the unit away.
To turn off the unit, set FUNCTION to (!) STANDBY
POWER so that the OPE/BATT indicator goes out.
To listen with the headphones, connect headphones with
a stereo mini plug to the Q (Headphones) jack.
QSOUND system
This system provides a rich, three dimensional sound area.
You can enjoy a more enhanced sound.
Press QSOUND.
● At higher volumes, turning QSOUND on may cause sound
distortion. In this case, turn the volume down.
4 ENGLISH