Filter
Top Products
ENGLISH 11
En
To prevent accidental erasure
Break off the plastic tabs on the cassette tape with a
screwdriver or other pointed tool after recording.
To record on the tape again
Cover the tab openings with adhesive tape, etc.
Tab for side A
Side A
DUBBING A TAPE
1 Press TAPE/POWER/6STANDBY to turn
the power off.
2 Insert a tape to be recorded on into deck 1
with the side to be recorded facing out.
3 Insert a tape to be played into deck 2 with
the side to be played facing out.
4 Press a then press w on deck 1 to enter
recording pause mode.
The power is turned on.
c is pressed simultaneously.
5 Press DUBB SPEED HIGH/LOW to select a
dubbing speed.
The HIGH-SPEED DUBBING indicator lights up:
Dubs at high speed.
The HIGH-SPEED DUBBING indicator goes off:
Dubs at normal speed.
6 Press c on deck 2.
a on deck 1 is released and recording starts.
To stop recording, press Z on deck 1 and deck 2.
The power will be automatically turned off.
NOTE
When recording near a television, noise may be
recorded. Move the unit away from the television.
MICROPHONE MIXING
Connect a microphone with a mini plug to
the MIC jack and play a source to be mixed.
To record the microphone mixing sound, insert a
tape in deck 1 and press w.
• During dubbing at high speed, the microphone
mixing sound is not recorded.
MIC VOL – Adjusts the microphone volume. If a
howling sound is produced, turn the volume
down.
• To prevent howling, hold the microphone away
from the speakers. The use of unidirectional type
microphones is also recommended.