Filter
Top Products
The clock is displayed. (The “:” between the hours and minutes
flashes.) When the power cord is plugged into an AC outlet
for the first time after purchase or when the clock setting is
canceled due to a power failure, the entire clock display
flashes.
1 Press CLOCK while pressing SHIFT,
2 Within 4 seconds, press - or -to designate
the hour and the minute.
Pressing either button changes both the hour and the minute,
Holding it down will vary the time rapidly by 10-minute interval,
and pressing it repeatedly will vary by 1 minute interval.
3 Press Il.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK while pressing SHIFT on the remote control before
completing step 3 to restore the previous time setting. This
cancels any new setting.
To view the clock when another display is in the display
Press CLOCK while pressing SHIFT on the remote control. The
time is displayed for 4 seconds and then the original display
reappears, However, the clock cannot be displayed during
recording.
To switch to the 24-hour standard
Press CLOCK while pressing SHIFT on the remote control and
then press
❑ within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
2—
The unit can be turned off automatically at a specified time.
Use the remote control.
1
2
Press SLEEP while pressing SHIFT.
Within 4 seconds, press 4 or ~ to specify
the time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
Specifi~d time
While the timer is in operation, the display indication is dimmer
than usual.
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that “SLEEP oFF
appears on the display.
~
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the removal
of the power cord. The current time needs to be reset.
I 4 ENGLISH