Filter
Top Products
Pg. 2
IS-WBCA, IS-WBCE
0511JD
Aiphone Corporation
1700 130th AVE NE * Bellevue, WA 98005
Ph: (800) 692-0200 * Fax: (425) 455-0071
tech@aiphone.com
TOLL FREE TECHNICAL SUPPORT:
(800) 692-0200
E-MAIL: tech@aiphone.com
MOUNTING / WIRING:
The IS-WBCA / IS-WBCE wall box comes pre-assembled with the beacon/strobe and the cage
attached. Mount the box to the wall, then wire the beacon/strobe, as well as the intercom sub
station. Complete installation by mounting the intercom sub station to the wall box. See below for
additional information.
12”
4”
OFF ON
NO
NO
C
NC
C
NC
1 2 3 4
Relay board on back of sub stations
+
-
24VDC
Back View Front View
Secure the wall box to any at surface
using mounting hardware suitable for
the surface you are mounting to. Top
mounting holes are 4” apart and top to
bottom mounting holes are 12” apart.
Connect the red and black wires from the beacon /
strobe to a 24V DC power supply. Red to positive
and black to negative. Connect the white trigger
wire to the N/O side of relay 2 on the sub station.
Connect a wire between the common of relay 2 and
the positive terminal of the 24V DC power supply.
See the sub station’s installation manual for its
complete wiring and dip switch setting options.
SPECIFICATIONS:
Surface box:
Mounting: Surface mount directly to wall
Material: 12 Guage Stainless Steel
Color: Polished Stainless Steel
Dimensions:
Box only 20” H x 8” W x 4” D
Including cage 26” H x 8” W x 4” D
Beacon / strobe:
Voltage: 24V DC
Current: 200mA
Wiring: Black: Ground
Red: +24V DC
White: Trigger
Operating Temp: -40°F to 149°F