Filter
Top Products
SECTION 10: WIRING
41 of 71
10.2.2 Satellite Heater Configuration
Satellite heater configuration is set by positioning of
jumpers on pin block J10 located on the control board
inside the heater compartment, See Page 41, Figure
24. Jumper position on J10, shown on Page 41,
Figure 24 will configure heater as a satellite heater.
(The jumper position for satellite is the same as the
jumper position of a central heater using a zone
sensor). Jumper on J9 may be left alone.
FIGURE 24: Satellite Heater Jumper Setting