Filter
Top Products
AC power connection: Power cable connection.
maintenance
Normal maintenance of the subwoofer consists of keeping the unit clean and dust-free. Use a soft cloth
or brush to remove dust without scratching or marring the finish. Do not use strong cleaner or solvents
of any kind. Avoid spray cleaners or waxes. They can produce spotty glossy areas.
Keep moisture away from the subwoofer. Avoid the temptation to place a plant that needs watering on
top of the subwoofer. If any part of the subwoofer gets wet, IMMEDIATELY unplug the power cord
from the wall. Then clean up the moisture. If you suspect moisture has gotten inside the subwoofer or
its amplifier, contact your authorized a/d/s/ dealer for service support.
voltage conversion
The subwoofer amplifier can be set to operate at 115 or 230 volts by using the voltage switch on the
control panel of the amplifier.
in case of difficulty
Loose connections, defective connecting cables or improper operation causes most difficulties with high
fidelity equipment. Often, problems show up after a change is made to the system or after the system
has been moved. Carefully check all connections. Before you disconnect any equipment label all
connecting cables and wires so you can reconnect them properly.
Some common difficulties and suggested remedies are described below. If these steps do not correct
the problem, contact your a/d/s/ dealer for assistance. If you want to contact the factory, write or call
the a/d/s/ Technical Service Department at:
Directed Electronics Inc.
1 Viper Way
Vista, CA 92081
800-753-0800 ext. 2032
Technical Service is open from 6:30am to 5:30pm PST.
12