Filter
Top Products
[13] Volume Knob
The front panel volume control knob
is motorized. It may be adjusted ei-
ther by hand or with the volume but-
tons on the remote control. The point
dot on the volume knob indicates the
volume level.
Description of Unit:
Rear Panel
[14] GND Ground Post
To reduce the chance for hum con
nect
the turntable ground lead to this at-
tachment point.
[15] Source Inputs
Source 1~7 inputs (R/L) Connects to
the line outputs of a CD player or
other analog audio source compo-
nent. Up to seven analog audio
source devices can be connected.
[16] Stereo Outputs
Rec Output: Connect rec output to
the Record or Input jacks of a record-
ing device.
Main Output: A line level stereo out-
put that connects to your amplifier’s
inputs.
[17] RS232 Control
The Adcom GFP-815 can be con-
trolled via the serial RS-232 port.
The serial port can be connected to
a system controller, PC or ‘dumb
terminal’ via a straight through
standard 9-pin(DB9) serial port cable
(MALE on one end and FEMALE on the
other end).
[18] Ext Remote
A remote infrared sensor can be con-
nected here.
[19] Auto turn on
A trigger, if properly hooked-up,
can
prove to be very convenient.
-in input jack use the 12V DC or AC
trigger in conjunction with another
device to turn the GFR-815 on and
off. The trigger output from the oth-
er device should go to the trigger
input on the rear panel of the GFP-
815.
-loop output jack is provided to
allow trigger control of additional
components in your system.
[20] AC Input
Connects the GFP-815 to a standard
electrical outlet using the supplied
power cord. Use the provided stand-
ard IEC AC cord to provide power to
the unit. The plug is a polarized type.
for electrical safety, observe proper
polarization at main out
let and do not
modify plug in any way. If it is ever
necessary, replace the fuse with a
fuse of identical type and rating for
continued protection. See “Trouble-
shooting” for more information.
Input 1 select
Sets the input level for input
source 1 to mm or mc for phono
cartridge input or line for other
analog devices.
Voltage switch (Bottom)
Sets the GFP-815 voltage to 120V
(U.S. standard) or 230V (interna-
tional standard).
Main power switch
Switches the GFP-815’s main pow-
er on and off.
Remote Control
The supplied remote con
trol, pictured
here, duplicates the frequently used
front panel controls. Two AAA bat-
teries are included. The model num-
ber of the remote control is RC815.