Acoustic Research AW722 Headphones User Manual


 
7
BATTERY INSTALLATION AND INFO (continued)
Charging the Rechargeable Batteries
Follow these steps to recharge the NiMH rechargeable batteries.
1. Connect the AC/DC main power adapter to the DC IN
power supply socket, located on the back of the recharging
cradle/transmitter.
2. Then, plug the adapter into an electrical outlet.
3. Place the headphones into recharging cradle/transmitter, with
the charge indicator facing to the front. Make sure the headphones
are placed in a completely vertical position, not leaning to either
side. If the headphones are placed correctly, the charge indicator
light illuminates.
4. Subsequent charging must be performed in about 15-17 hours.
NiMH Rechargeable Battery Memory Effect
When an NiMH rechargeable battery is first used, it is important to fully
charge it and then allow it to discharge three times in order to maximize
the battery’s storage capacity. When a battery is recharged before
it is completely discharged, it develops a memory that will limit the
amount of charge in the future. This reduces the battery’s storage
capacity for subsequent charges and so reduces the amount of time
your headphones can be used before recharging is necessary.
NiMH Natural Power Discharge
Due to their chemical design, all rechargeable batteries incur some
degree of natural discharge. This means they automatically lose their
charge in varying degrees, even when not in use. The size of this power
loss varies, depending on the battery’s type, size, design, internal
resistance and, most especially, the temperature. The higher the
temperature, the greater the power loss through natural discharge.
NiMH Battery Warning
1. To avoid risk of fire, explosion and injury, do not attempt to recharge
non-rechargeable batteries.
2. Respect the environment and the law. Before disposing of
rechargeable batteries, ask your retailer if they can be recycled and
whether or not the retailer collects rechargeable batteries
for recycling.
6
BATTERY INSTALLATION AND INFORMATION
Your wireless headphone unit requires two rechargeable AAA batteries.
The two rechargeable batteries that are supplied with your wireless
headphones are uncharged. Before you can use the wireless headphones,
the batteries must be charged. Follow these steps to charge and install
the batteries.
Installing the Rechargeable Batteries
Take care to follow these steps to correctly charge and install the batteries.
1. On the left earphone, locate the battery compartment and the word
“Open.” Use your fingernail in the groove on top of the battery
compartment to lift the cover.
2. Insert two AAA rechargeable batteries (included), carefully following
the markings inside to ensure the batteries are inserted properly, with
the + and – ends in the correct positions.
3. Replace the battery compartment cover.
SUPPLIED ACCESSORIES
This headphone system includes accessories that enable you to use your
wireless headphone set in a number of ways. (See sections on Standard
Usage, page 8, and Alternate Installation Configuration, page 9).
Stereo Y adapter cable
(RCA/3.5 mm jack)
Main power adapter
(AC/DC: 120 V ~ 60 Hz, 12 V = 200mA)
Stereo cable
(3.5 mm jacks)
3.5 mm/6.35 mm jack adapter
Rechargeable batteries
(600mAH, NiMH)
AW722_AW722NAIBREVB.qxd 2/21/06 1:33 PM Page 6