Filter
Top Products
AVR250
E-32
AVR250
E-33
English
IR Remote Codes
The following information is supplied for owners of advanced programmable remote controls, such as the
Philips ‘Pronto’ and similar devices, where it is possible to program remote codes directly into the device.
The coding system for the AVR250 is based on the Philips RC-5 standard. The main system control uses
RC-5 system codes ‘16’, with the tuner section using system code ‘17’ (this is to provide compatability
with existing ARCAM tuners). So, for example, to program in a ‘Stand-by’ command, use the command
‘16-124’.
Zone 2 also uses RC-5 system code 16 as standard, as Zone 2 is normally operated in a separate room
using a standard (system code 16) remote control.
Main system control code, system code 16. Items shown in THIS STYLE indicate the equivalent remote
control button of the supplied CR-80 remote control.
Command Command code Command Command code
Stand-by 124
MODE
32
On 123 Mono mode 106
Power toggle 12 Stereo mode 107
Display (DIS) 59 Dolby PLII Movie 108
Menu (MENU) 82 Dolby PLII Music 109
Info 55 (Reserved) 102
Dolby PL Emulation 110
Mute 119 DTS Neo:6 Cinema 111
Un-mute 120 DTS Neo:6 Music 112
Mute toggle (MUTE) 13 Dolby PLIIx Movie 103
Volume up 16 Dolby PLIIx Music 104
Volume down 17 (Reserved) 105
SAT input 0 Effect (FX) 70
AV input 2 Effect off 63
TUNER input 3 Effect: Music 64
DVD input 4 Effect: Party 65
TAPE input 5 Effect: Club 66
VCR input 6 Effect: Hall 67
PVR input (AUX) 8 Effect: Sport 68
CD input 7 Effect: Church 69
DVD-A input 9
Trim menu (TRM) 37
Stereo Direct on 78 Sub trim menu (SUB) 51
Stereo Direct off 79 Lip sync. (SYN) 50
Stereo Direct toggle 10
Satellite video 19
Up 86 AV video 20
Down 85 DVD video 22
Left 81 Tape video 23
Right 80 VCR video 24
OK 87 Video standard 126
Zone 2 mode on 47 Preset/Tune down (P-) 57
Zone 2 mode off 48 Preset/Tune up (P+) 56
Preset/Tune mode toggle 54