3Com 3C18320 Home Theater System User Manual


  Open as PDF
of 5
 
Installing in a
LinkSwitch Hub
Remove the blanking plate from the hub which is to receive the FDDI MIC
Media Module. The relevant manual will tell you where to find the plate.
1
Keep the blanking plate in a safe place so that it can be replaced if the
FDDI MIC Media Module is removed.
2
Holding the mounting panel, insert the edge connector end of the FDDI
MIC Media Module, with the header pins side down, into the rear of the
hub.
3
Slide the FDDI MIC Media Module in carefully to engage in the slot and
push it fully home.
4
Fix the mounting panel of the FDDI MIC Media Module to the hub using
the two screws from the blanking plate.
Connection to the
FDDI Network
Remove the launcher-protecting device from the MIC connector. Either of
the two types of protector shown Figure 3 and Figure 4 may be
encountered.
Figure 3
Type A protector
Figure 4
Type B protector
Connect the MIC connector to the FDDI MIC Media Module's connector.
Push firmly home.
WARNING:
Take care to keep the ends of the connectors clean. Wipe with
a tissue moistened with ethanol if necessary.
 previous