Asked by dwight on 08/09/2008 4  Answers

ManualsOnline posted an answer 6 years, 9 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Ken posted an answer 6 years, 5 months ago

5 The standard manual doesn't show the fuel line routing. But I've worked it out anyhow. Run 3 new lines as follows: Route 1 line from the fuel filter outlet of fuel tank to the Carb inlet brass tube - the one with the 90 degree bend and is on the side of the Carb closest to the muffler. Route 2nd line from the brass Carb outlet tube (straight tube on the opposite side of the Carb from the muffler) to the suction side of the primer bulb. Route 3rd line from the pressure side of the primer bulb into the return hole on the fuel tank. Pull it about 1/2 inch into the tank with some needle nose pliers. As needed, change the air & gas filters, the primer bulb and spark plug. Some Carb cleaning may be needed, be careful - small parts. Also, if the muffler is loaded up with oil soaked carbon or other crud, the engine will not run/rev properly until the muffler is cleaned out or replaced.
Was this answer helpful?

K posted an answer 6 years, 1 month ago

5 Thanks for the great instructions, they werea big help in replacing the lines on my 410r
Was this answer helpful?

joe posted an answer 1 month, 1 week ago

5 my fuel lines became disconnected,I dont know where the fuel lines go,Does anyone have a fuel line diagram
Was this answer helpful?

Add Your Answer