need pinout for Logitech z4 speakers remote control 9 pin as I lost the remote cable.

Asked by John on 04/01/2011 19  Answers

ManualsOnline posted an answer 7 years, 3 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
9 What is the pin order in the DB9 female connector on the system?? Is it like this??
Was this answer helpful?
6 Logitech Z4 DB9 remote pinout scematic diagram 1 L OUT 2 L IN 3 S IN 4 ON 5 +5V 6 R OUT 7 R IN 8 GND 9 LED? To run the Z4 without a remote: Connect 4-5 Power Switch Connect 1-2 Route Left Channel Connect 6-7 Route Right Channel No Sub volume adjustement: Add 10k resistor from 1-3 Mix left channel to sub Add 10k resistor from 6-3 Mix right channel to sub Sub volume adjustment: Add 10k resistor from 1-Pot top Mix left channel to sub Add 10k resistor from 6-Pot top Mix right channel to sub Add wire from Pot center to pin 3 Add wire from 8- Pot bottom Uncertain what 9 is used for. Possible LED?
Was this answer helpful?
0 good job
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.