I just received a used set of JVC HA-W100RF wireless headphones but all the connectors aren't there and I'm not sure how to hook them up to use with my home theater system....

Asked by Crystal on 11/03/2011 1  Answer

ManualsOnline posted an answer 12 years, 6 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
0 I just found one of these in my closet I purchased about 8-9 years ago and figured out how to set it up. It did not work with my old TV years ago but works with a newer home theatre unit. All you really need that came with the unit is the base unit, the power cable/plug and the little squiggly wire that connects from the base to the headphones to recharge the battery when needed. If you have the squiggly wire plug it into the base unit where it indicates "charge" and then connect the headphones to the base unit with the squiggly to charge the headphone batteries. Wait a couple hours. Once the headphones are charged you can unplug the squiggly wire until they need charging again. Next get a pair of standard RCA audio cables (radio shack) usually with red and white connectors and go from the Audio Out jacks on your home theatre to the the inputs on the back of the base unit. If there is a usable sound signal from the home theatre the green light on the front of the base unit will come on and stay on. Turn on the headphones. My headphones connected automatically to the base but there are tuning buttons on both the base and headphones you may need to adjust. The green light goes off when there is no signal but the base is always on. Good luck.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.