Yamaha MSR100 Speaker User Manual


 
4
ENGLISH
CAUTION
• Keep this unit away from the following locations:
- Locations exposed to oil splashes or steam, such as near
cooking stoves, humidifiers, etc.
- Unstable surfaces, such as a wobbly table or slope.
- Locations exposed to excessive heat, such as inside a car
with all the windows closed, or places that receive direct
sunlight.
- Locations subject to excessive humidity or dust accumula-
tion.
Do not place the power cord close to a heater. It may melt,
causing fire or electrical shock.
Hold the power cord plug when disconnecting it from an AC
outlet. Never pull the cord. A damaged power cord is a poten-
tial fire and electrical shock hazard.
Do not touch the power plug with wet hands. Doing so is a po-
tential electrical shock hazard.
This unit has ventilation holes at the rear to prevent the inter-
nal temperature rising too high. Do not block them. Blocked
ventilation holes are a fire hazard.
In particular, do not
-
place the unit on its side or upside down,
-
place the unit in any poorly-ventilated location such as a
bookcase or closet (other than on the dedicated rack),
-
cover the unit with a table cloth or place it on a carpet or
bed.
To relocate the unit, turn the power switch off, remove the
power plug from the AC outlet, and remove all connecting ca-
bles. Damaged cables may cause fire or electrical shock.
Allow enough free space around the unit for normal ventila-
tion. This should be: 30 cm at the sides, 30 cm behind, and 30
cm above. Open a ventilation hole. If the airflow is not ade-
quate, the unit will heat up inside and may cause a fire.
Turn off all musical instruments, audio equipment, and
speakers when connecting to this unit. Use the correct con-
necting cables and connect as specified.
Always lower the volume control to minimum before turning
on the power to this unit. A sudden blast of sound may dam-
age your hearing.
Do not output distorted sounds for long periods of time, as
this will cause the speaker to heat up, leading to a fire hazard.
Do not raise the volume of speakers to a level that makes you
feel uncomfortable. Listening to loud music for long periods
can damage your hearing.
If you know you will not use this unit for a long period of time,
such as when going on vacation, remove the power plug from
the AC outlet. Leaving it connected is a potential fire hazard.
To prevent electrical shock when cleaning the unit, remove
the power plug from the AC outlet.
PRECAUTIONS – FOR CORRECT OPERATION –
XLR-type connectors are wired as follows: pin 1: ground, pin
2: hot (+), and pin 3: cold (–).
This speaker system is not magnetically shielded. If a nearby
monitor exhibits any distortion or unnatural color shift, move
the speaker further away from the monitor.
Using a cell phone (mobile telephone) near this unit may induce
noise. If noise occurs, use the telephone away from the unit.
Installation Operation
Maintenance
Connector pin assignments
Installation
Influence on cell phone usage