Filter
Top Products
E-6
OPERATIONS
1 Press STANDBY/ON to turn on this unit and also
RX-E100.
2 Set RX-E100 to cassette deck function mode.
3 Press to open the tape tray and place a recorded
tape on the tray.
4 Press to close the tape tray.
5 Press MODE to select the reverse mode.
Each time you press MODE, the reverse mode
changes and the corresponding mode indicator lights
up as follows:
: One side of the tape is played back.
: Both sides of the tape are played back.
: Both sides of the tape are played back up to 8
times continuously.
Playback
You can use any type of tape, since the unit automatically
detects the tape type.
6 Press DIRECTION to change the direction of the
tape.
• If you place the tape on the tray with side A
upward, # indicates playing side A and @
indicates playing side B.
7 Select the noise reduction type using DOLBY NR if
necessary.
8 Press # to start play.
To stop play
Press &.
To eject a tape
Press to open the tape tray and remove the tape from
the tray.
To adjust the volume level
Use the volume control of RX-E100.
To fast-forward or rewind the tape
Press ⁄ or ! to fast-forward or rewind the tape
during stop mode.
To search for the beginning of a
selection
Press ⁄ or ! to search for the beginning of the next
or current selection during play mode.
Notes
• The blank interval between selections must be at least 4
seconds long.
• The search function may not operate properly with tapes
recorded at a low recording level or which have excessive
noise.
• When you play the beginning part or end part of the tape, the
search function may not work correctly.
Tape Tray
&#
! / ⁄ DIRECTIONMODESTANDBY/
ON
MAX
MIN
REC LEVEL
DOLBY NR
REC/
PAUSE
MODE
COUNTER
RESET
DIRECTION
NATURAL SOUND STEREO CASSETTE DECK KX-E100
STANDBY/ON
DOLBY B-C NR
DOLBY NR