Yamaha DVX-S100 Home Theater System User Manual


 
14
CONNECTIONS
Connecting TV and audio/video
components
Types of video jacks
1 COMPONENT VIDEO jacks (U.S.A., Canada,
Australia and General models)
Transmit color difference (PB/CB, PR/CR) and luminance
separately and provide the best quality picture.
2 VIDEO jack
Conventional composite video signal.
3 S VIDEO jack
Transmits color and luminance separately and achieves
high-quality color reproduction.
Notes
Each type of video jack works independently. Signals input
through the composite video and S video jacks are only output
through the corresponding composite video and S video jacks.
When you connect this unit to a video monitor, a video
component and a recording component, connect the same types
of jack, for example, the video jack on this unit to the video
jack on the video component.
The description of the component video jacks may differ
depending on the component (e.g. Y, CB, CR/Y, PB, PR/Y, B-Y,
R-Y etc.). When using these jacks, refer also to the operation
instructions for the component being connected.
Do not connect this unit to a video monitor through a video
cassette recorder. If you do so, the picture may not be played
back properly due to the copyright protection technology
incorporated in this unit.
When progressive output (p.38) is selected in the DVD mode,
video signals are only output from the component video jacks.
321
PR PB Y
Types of audio jacks
1 COAXIAL jack
Connects a coaxial pin cable and provides the better
quality sound than analog audio jacks.
2 OPTICAL jack
Connects an optical fiber cable and provides the better
quality sound than analog audio jacks.
3 Analog audio jacks
Connect an audio pin cable.
y
1 and 2 are digital jacks.
You can use the digital jacks to input PCM, Dolby Digital and
DTS bitstreams.
All digital input jacks are acceptable for 96-kHz sampling
digital signals.
Notes
Digital output jack and analog OUT (Rec) jacks are
independent. Only digital signals are output from digital output
jack and analog signals from OUT (Rec) jacks.
The OPTICAL jacks on this unit conform to the EIA standard.
If you use an optical cable that does not conform to this
standard, this unit may not function properly.
Once you have connected a recording component to this unit,
keep its power turned on while using this unit. If the power is
off, this unit may distort the sound from other components.
Anti-dust cap
Remove the cap covering the OPTICAL jacks when
connecting an optical cable. Safely store the cap and
always re-insert it in the terminal when the terminal is not
in use. (This cap prevents the entrance of dust.)
1 23
L
R
Anti-dust cap
104_S100_10-20_EN 02.5.13, 1:27 PM14