Filter
Top Products
QUICK PROGRAMMING GUIDE
MODEL BXAUDIO4X4
FOUR ZONE – FOUR SOURCE
COMPLETE AUDIO CONTROLLER/AMPLIFIER SYSTEM
[Complete Programming Instructions can be found in the Installation Instruction Manual]
30 31
32
33
34 36 37
35
38
39
40
42
43
44
41
42
Programming Button Layout
PROGRAMMING KEYPAD BUTTONS (SINGLE COMMANDS)
Note: When learning IR commands into the BXAUDIO4X4 Controller, make sure the IR Learning eye is free from IR
interference that might result in IR learning error or intermittent IR commands. IR Interference could be caused by any
of the following: Sunlight, Fluorescent light, LCD or Plasma displays, Computer Monitors, EMI etc..
1. Make sure an LCKP4 Keypad is plugged into the Zone 1 Keypad port and the Keypad is ON [32].
2. Enable PROGRAM MODE (Set Mode Switch [10] in the ‘UP’ position).
3. Press the SOURCE 1 BUTTON [35] on the LC4KP Keypad for the device to be programmed.
4. Press the PROGRAM KEYPAD [2] button on the front of the BXAUDIO4X4.
a. Confirm the PROGRAM KEYPAD LED [11] is illuminated GREEN.
5. Press the BUTTON on the LC4KP KEYPAD to be programmed
a. Confirm the STATUS LED [14] is illuminated GREEN
6. Aim the Manufactures Source Remote at the IR Learning eye on the front of the BXAUDIO4X4 [5].
7. Press and Release the corresponding button on the devices remote (make sure to use a short, quick press of the
devices remote when learning commands).
8. If the code was learned correctly the STATUS LED will turn OFF and the PROGRAM KEYPAD LED will remain
GREEN. (To program a Sequence of commands under this button, proceed to step 2 in the following section).
Note: If the code is learned incorrectly, the PROGAM LED will blink RED three times. In this case, repeat steps 4
through 7.
9. Repeat steps 4 through 7 for all of the desired IR commands for Source #1.
10. Repeat Steps 2 through 8 for Sources 2 through 4.