Filter
Top Products
O
PERATING
I
NSTRUCTIONS
1. Install two (2) AA batteries. If you’re using rechar-
geable batteries, they must be charged before using.
2. Plug the microphone cord into the “Mic” jack on top
of the Transmitter.
3. Place the Transmitter in the belt clip case provided.
4. Turn the power switch on top of the Transmitter
to “On.”
5. The microphone should be placed as close to the speak-
er’s mouth as is practical. For lapel mics, attach the
microphone to a collar, lapel, or tie.
The transmitter can be placed in a pants pocket, or clipped
onto a belt or waistband. Make sure the Transmitter is turned
OFF when not in use.
Note On The Transmitter Antenna:
The microphone cord is the transmitting antenna. Do not
bunch up the cord or wrap it around the transmitter. For max-
imum range, the cord should hang as straight as possible.
B
ATTERY
I
NSTRUCTIONS
This transmitter can use disposable AA batteries (alkaline or
lithium) or a Williams Sound rechargeable battery (BAT
026). We recommend using BAT 026 AA Ni-Cad or BAT 001
AA Alkaline batteries. BAT 026 batteries will last about 8
hours per charge when used with Williams Sound
Transmitters. BAT 001 batteries will last approx. 12 hours
when used with Williams Sound Transmitters. Batteries from
other suppliers may provide different operating life.
E
XPECTED
B
ATTERY
L
IFE
Alkaline batteries (BAT 001): 12 hrs
Rechargeable Ni-Cad Batteries (BAT 026):
8 hrs per charge
I
NSTALLING AND
R
EPLACING
B
ATTERIES
1. Open the battery compartment by lifting the tab on the
bottom of the transmitter with a coin or finger.
2. To remove depleted batteries, pull up on the fabric strip.
3. To install new batteries, press them into place over the
fabric strip. Be sure to observe proper polarity (+/–).
4. Close the lid.
5. When the sound becomes weak or distorted, replace or
recharge batteries. If recharging, use the Williams Sound
CHG 200 or CHG 1600 Battery Charger.
W
ARRANTY
N
OTICE
Your Williams Sound Transmitter is engineered and designed
to provide you with many years of reliable service. Williams
Sound warrants it against defects in materials and workman-
ship for FIVE (5) years EXCEPT FOR microphones, batter-
ies, chargers, cables, carry cases, and all other accessory
products. Accessory products carry a 90 day warranty.
If the transmitter fails within the warranty period, Williams
Sound will determine whether to repair or replace it. This
warranty does not apply to physical damage, transmitters that
have been abused or mis-used, or modified.
Williams Sound Products are NOT designed for use in
extreme temperature, humidity, or chemical environments.
The introduction of chemicals such as chlorine, salt water, or
human sweat into the product will cause damage to the cir-
cuitry. Damage due to these causes IS NOT covered under
the product warranty.
T1–173 & T1-174 Transmitter (AA)
Instructions For Use & Care
+–
+
–
Battery
Compartment
Pry
Slot
Rear of
Transmitter
Note Proper
Polarity
Mic
Williams Sound FM
Off
On
FM
On/Off
Switch
Mic
Jack
On/Off
Indicator
Williams Sound
®
Helping People Hear
www.tour-guide-systems.com
©2000, Williams Sound Corp. FRM 440A
English
Inglés