Whirlwind SAT-1 Headphones User Manual


 
1: Volume Controls
Provides separate left/right
volume control. When used in
conjunction with the
Stereo/Mono switch, you can
achieve a “mix” between
channels.
2: Headphone Outputs
Two outputs are provided for
each of the two sections on the
Satellite module. Each set is
wired in parallel.
3: Stereo/Mono Switches
One switch is supplied for each
section of the SAT-1
4: IN
Input to Satellite Module.
Standard XLR jack is provided
so that hookup can be
accomplished with standard
microphone cables.
5: THRU
Wired parallel to the input jack,
can be used for “Daisy
Chaining” modules.
Optional Equipment: PCHLIP for mounting SAT-1 on a
microphone stand. Available at authorized Whirlwind dealers.
When using headphone impedances of 50 ohms or less, do
not power the SAT-1 with an amplifier rated greater than 45
watts. Failure to observe this will burn out the current limiting
resistors inside the unit and void the warranty.
!
L
R
STEREO
MONO
1 2
PHONES PHONES
SAT-1
SATELLITE
MODULE
IN THRU
1
2
3
4
5
99 Ling Rd
Rochester, NY 14612
585 663-8820 Fax 585 865-8930
SAT-1
Satellite Module and
Headphone Breakout Box
XLR PINOUT
Pin 1 = shield
Pin 2 = ring (right)
Pin 3 = tip (left)