Toshiba SD-V57HTSU Home Theater System User Manual


 
Connections (Continued)
12
Basic TV Connections
Make one of the following connections, depending on
the capabilities of your TV.
RF coaxial connection
Connect the RF.OUT jack on the DVD/VCR Receiver to
the antenna in jack on the TV using the 75-ohm Coaxial
Cable supplied (R).
Note
If you use this connection, tune the TV to the
DVD/VCR Receiver’s RF output channel (CH 3 or 4).
How to set the DVD/VCR Receivers RF output chan-
nel
When the DVD/VCR Receiver is turned off,
press and
hold CH/PRESET ( / ) on the front panel for about
five seconds to change the RF output channel (CH 03
or CH 04). “RF-03” or “RF-04” appears in the display
window.
Audio/Video connection
1. Connect the DVD/VCR VIDEO OUT jack on the
DVD/VCR Receiver to the video in jack on the TV
using the supplied video cable (V).
2. Connect the Left and Right DVD/VCR AUDIO OUT
jacks on the DVD/VCR Receiver to the audio
left/right in jacks on the TV (A) using the supplied
audio cables.
Note
If you use this connection, set the TV’s source selector
to VIDEO.
Optional TV Connections
Note
DVD playback can also be done using the S-VIDEO OUT
and COMPONENT/PROGRESSIVE SCAN VIDEO OUT
connection options below.
The tuner and VCR ONLY
output through the RF.OUT (R) or DVD/VCR OUT (A,
V) jack. (See left)
S-Video Connection
1. Connect the S-VIDEO OUT jack on the DVD/VCR
Receiver to the S-Video in jack on the TV using the
S-Video cable (S).
2. Connect the Left and Right AUDIO OUT jacks on
the DVD/VCR Receiver to the audio left/right in
jacks on the TV using the supplied audio cables (A).
Component Video (ColorStream
®
) connection
1. Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVD/VCR Receiver to the
corresponding in jacks on the TV using Y Pb Pr
cables (C).
2. Connect the Left and Right AUDIO OUT jacks of the
DVD/VCR Receiver to the audio left/right in jacks on
the TV (A) using the supplied audio cables.
Progressive Scan (ColorStreamPro
®
) connection
If your television is a high-definition or “digital ready”
television, you may take advantage of the DVD/VCR
Receiver’s progressive scan output for the highest
video resolution.
If your TV does not accept the Progressive Scan for-
mat, the picture will appear scrambled if you try
Progressive Scan on the DVD/VCR Receiver.
1. Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVD/VCR Receiver to the
corresponding in jacks on the TV using Y Pb Pr
cable (C).
2. Connect the Left and Right AUDIO OUT jacks of the
DVD/VCR Receiver to the audio left/right in jacks on
the TV (A) using the supplied audio cables.
Notes
Set the Progressive Scan to “On” on the DVD setup
menu for progressive signal, see page 21.
Progressive scan does not work with the analog video
connections (yellow VIDEO OUT and S-VIDEO OUT
jack).
ANTENNA
INPUT
R
L
R
Y
Pb
Pr
COMPONENT/PROGRESSIVE
SCAN VIDEO INPUT
AUDIO INPUT
L
VIDEO
INPUT
S-VIDEO
INPUT
Rear of TV
Rear of DVD/VCR Receiver
S
A V C