Toshiba SD-V57HTSU Home Theater System User Manual


 
Rear Panel
Do not touch the inner pins of the jacks on the rear
panel.
Electrostatic discharge may cause permanent dam-
age to the unit.
Caution
Never throw batteries into a fire.
Notes
Be sure to use AAA size batteries.
Dispose of batteries in a designated disposal area.
Batteries should always be disposed of with the environment
in mind. Always dispose of batteries in accordance with
applicable laws and regulations.
If the remote control does not operate correctly, or if the
operating range becomes reduced, replace batteries with
new ones.
When necessary to replace batteries in the remote control,
always replace both batteries with new ones. Never mix bat-
tery types or use new and used batteries in combination.
Always remove batteries from remote control if they are dead
or if the remote control is not to be used for an extended
period of time. This will prevent battery acid from leaking into
the battery compartment.
VCR IN LINE 1
(VIDEO IN/AUDIO IN
(Left/Right))
Connect the audio/video output of an external
source (Audio system, TV/Monitor, Another
VCR).
ANT.IN
Connect the VHF/UHF/CATV
antenna to this terminal.
DVD/VCR OUT (VIDEO/AUDIO (Left/Right))
Connect to a TV with video and audio inputs.
AC Power Cord
Plug into the power source.
S-VIDEO OUT (DVD OUT)
Connect to a S-Video Input on TV. FOR DVD VIEWING ONLY.
DIGITAL AUDIO IN (OPTICAL)
Connect to a digital audio output on a digital device.
COMPONENT/PROGRESSIVE SCAN VIDEO OUT
(Y Pb Pr) (DVD OUT)
Connect to a TV with Y Pb Pr inputs. FOR DVD
VIEWING ONLY.
RF.OUT
Connect to a TV with RF coaxial inputs.
AM Antenna Connectors
Connect the AM antenna to this terminal.
FM Antenna Connectors
Connect the FM antenna to this terminal.
SPEAKER Connectors
Connect the six supplied speakers to these terminals.
10
Remote Control Operation Range
Point the remote control at the remote sensor and
press the buttons.
Distance: About 7m (23ft) from the front of the
remote sensor
Angle: About 30° in each direction of the front of the
remote sensor
Remote control battery installation
Detach the battery cover on the rear of
the remote control, and insert two R03
(size AAA) batteries with and
aligned correctly.
AAA
AAA