Toshiba SD-43HK Home Theater System User Manual


 
SETUP
Speaker Setup
33 34
Setting up Speaker Mode and Delay Time
Each time the button is pressed, a different mode selection is
displayed on the front panel display as shown below.
The display changes depending on the current audio output mode (PRO LOGIC II, STEREO,
etc.).
Speaker delay time setting is a professional sound volume adjustment method for
audio enthusiast. For home use, refer to "Setting up the Ideal Speaker Positions" below
to install speakers in appropriate locations.
DIGITAL
L
LS RS
C
LFT
R
F SP SMALL
C SP SMALL
R SP SMALL
SW SP USE
C DLY MS
R DLY MS
DIGITAL
L
LS RS
C
LFT
R
DIGITAL
L
LS RS
C
LFT
R
DIGITAL
L
LS RS
C
LFT
R
DIGITAL
L
LS RS
C
LFT
R
DIGITAL
L
LS RS
C
LFT
R
S
p
e
a
k
e
r
M
o
d
e
Delay
Time
Front speaker: Small
Center speaker: Small
Rear speaker: Small
Subwoofer: Use
Center Speaker Delay Time
Rear Speaker Delay Time
Center speaker: Not Used
Rear speaker: Not Used
Setting up Delay Time from 00~05ms
Setting up Delay Time from 00~15ms
1
Press the LEFT/RIGHT ( / ) button to
select the desired item.
Press the SPK MODE button.
2
SMALL: When this setting is selected, low frequencies of below 200 Hz are assigned to
the subwoofer only.
USE: Select when using speakers.
NONE: Select this when no speakers are installed.
5.3 ms
10.6 ms
15.9 ms
Df: The distance from FRONT SPEAKER
Dc: The distance from CENTER SPEAKER
Ds: The distance from SURROUND SPEAKER
Setting REAR (SURROUND) SPEAKERS
If the distance of Df is equal to the distance of
Ds in the figure, set the mode as 0ms.
Otherwise, change the setting according to the
table.
Setting CENTER SPEAKER
If the distance of Dc is equal to or longer than
the distance of Df in the figure, set the mode
as 0ms. Otherwise, change the setting
according to the table.
When 5.1CH Surround Sound is played, you can enjoy the best sound if the distance between you and each speaker is
the same. Since the sounds arrive at the listening position at different times depending on the placement of speakers, you
can adjust this difference by adding a delay effect to the sound of the Center Speaker and Surround Speakers.
Setting up the Speaker Delay Time
Distance between Df and Dc Delay Time
Delay Time
Ideal CENTER SPEAKER placement
1.3 ms
2.6 ms
3.9 ms
5.3 ms
Distance between Ds and Dc
50
100
150
200
200
400
600
It is desirable to place all speakers within this circle.
Ideal SURROUND
SPEAKER placement
C SP NONE
R SP NONE
DIGITAL
L
LS RS
C
LFT
R
DIGITAL
L
LS RS
C
LFT
R
Note
Note