Technicolor - Thomson DPL4911 Home Theater System User Manual


 
EN
7
Connections
Connecting to AM / FM antenna
Connect the supplied AM loop antenna to the AM jack.
Position the loop antenna to receive the clearest sound.
Connect the supplied FM antenna to the FM jack. Move
the antenna in various direction until the clearest signal
is received.
Note
Keep the antenna as far away as possible from the TV,
VCR or any radiation source to prevent unwanted noise.
If you have poor FM reception
For better FM reception, use a 75 ohm coaxial cable (not
supplied) to connect the system to an outdoor FM antenna
as shown.
Connecting to Speakers
Connect the supplied speakers ,using the supplied speaker
wires to match the colors of the jacks and speaker wires.
Connect the supplied speaker wire its corresponding
terminal jacks.
To avoid short-circuiting the speakers
Short-circuiting of the speakers may damage the system.
To prevent this, make sure to take the following precau-
tions when connecting the speakers.
Make sure the stripped end of each speaker cord does
not touch another speaker terminal or the stripped end
of another speaker cord.
Note
Be sure to match the speaker cord correctly.
For optimal sound performance, use the supplied speakers.
Do not connect speakers with an impendance lower than
the speakers supplied.
Examples of poor conditions of the speaker cord
Stripped speaker cord is touching another speaker
terminal.
Stripped cords are touching each other due to excessive
removal of insulation.
FM 75
AM
6 ohms
FL
FR
C
SR
SL SW
+
-
Grey / grey stripped
Blue / grey stripped
Red / grey stripped
White / grey stripped
Green / grey stripped
Purple / grey stripped
FRONT SPEAKERS
REAR SPEAKERS
SUBWOOFER
CENTRE SPEAKER
CENTER
+
-
RIGHT
+
-
LEFT
+
-
+
-
REAR
+
-
REAR
+
-
Green
Purple
Black
Grey
Black
Black
Black
Black
Red
FL
FR
C
SR
SL SW
+
-
Black
White
Blue
DPL4911
DPL911VD