Telex SR-50 Speaker User Manual


 
PERSONAL
listening systems
insightdesign@wanadoo.fr
project
client
date
Sound Mate Product Logo
Telex Communications, Inc.
Burnsville, MN, USA
February 26th 2004
version
comments
v 1.0
Blue on CMYK Logo - Pantone 7455 C
A NL-4S Neckloop Assembly
(for use with hearing aids equipped with telecoils)
B HED-2 Collapsible Lightweight
Headphone
C HED-3 Full Cushion Noise Reduction
Headphones
D AFC-1 Under Chin Eartube
(for use with CMT-98 and Telethin Earphone Driver)
E ES-1 Ear Speaker
F DEB-2 Dual Earbud
with cord
G SEB-1 Single Earbud
with cord
H CCS-12 Replacement Cushion Covers
(Package of 12, for SEB-1, DEB-2 and HED-1 earbuds)
I HED-1 Ultra Lightweight Headphone
J HM-2 Head Worn Mic
K PH-21 Noise Canceling Head Worn Mic
L OLM-10 Mic
(Supplied with PST-170)
M HGA-1 1/2 Wave Dipole Gain Antenna
SPECIFICATIONS
There are 17 standard frequency options for the following products:
72.1, 72.2, 72.3, 72.4, 72.5, 72.6, 72.7, 72.8, 72.9, 74.7, 75.3, 75.4, 75.5, 75.6, 75.7, 75.8, 75.9 MHz
RF Frequency Range 72 to 76 MHz
Modulation: FM ±25 KHz deviation
Signal-To-Noise Ratio 58 dB (77 dB with E.D.R.)
Maximum Deviation ±25 KHz
Audio Input Balanced XLR-3F and unbalanced 1/4”
Antenna 1/4” wave telescoping omnidirectional
Audio Controls Audio input level, monitor jack volume, E.D.R.
Power Requirements 13-20 Vdc or 12 Vac; 115Vac 60 Hz @ 300 mA
plug-in wallpack power supply
Dimensions H 1-3/4” (4.5 cm) x W 7-1/2” (19.2 cm) x
D 5.9” (15 cm)
FCC ID B5DM522
Backlit LCD Display Ch., Freq, Audio Meter, Input setup,
RF level, and E.D.R.
RF Output Power @ 3M
Normal 25K µV/m
High 80K µV/m
ST-300 17-channel TranSmiTTer (CATALOG NO. 71912-000)
Sr-400 17-channel receiVer (CATALOG NO. 71913-000)
Power Requirements (2) AA batteries, Alkaline, NiMH or NICAD
20 hours Alkaline, 16 hours NiMH, 8 hours NICAD
Audio Frequency Response <3 dB Variation (100 Hz-10 KHz)
Modulation: FM ±25 KHz deviation
Sensitivity 0.5 µV typical, 1.0 µV maximum,12 dB SINAD
Image Rejection >65 dB
Signal-To-Noise Ratio >77 dB with E.D.R.
Distortion <2% T.H.D.
Audio Output @ 10% distortion into 8 Ohms: 2.0V / 15mW 3.0V / 80mV
into 32 Ohms: 2.0V / 10mW 3.0V / 50mW
Antenna Type omnidirectional in earphone cord
Audio Controls
Volume, On/Off, High frequency boost control, E.D.R.
Earphone Connector Type 3.5 mm stereo or mono
Dimensions
H 4” (101 mm) x W 2-3/4” (70 mm) x D 1” (25 mm)
Visual Indicators Backlit LCD Channel, Hi Freq, E.D.R.
Charger Contacts Bottom of unit
FCC Complies with Part 15
Audio Input Characteristics Mic TA4M connector, 7.75 mV RMS input
for ±25 KHz deviation. Impedance, 10K Ohms,
nominal. Aux. Input, Female 3.5mm. 100mV
Unbalanced, 100K Ohm nominal
Antenna Permanently attached trailing wire
Modulation: FM ±25 KHz deviation
Frequency Response (System) 100 Hz to 10,000 Hz
System Signal-To-Noise 58 dB (77 dB with E.D.R.)
Pre-emphasis 115 µ seconds
Maximum RF Power 80K µV/m @ 3 m
Power Requirements (2) AA batteries, Alkaline, NiMH or NICAD
8 hours Alkaline, 8 hours NiMH, 4 hours NICAD
FCC ID B5DM521
PST-170 17-channel TranSmiTTer (CATALOG NO. 71914-000)
Sr-50 receiVer (CATALOG NO. 71155-XXX*)
Americas Telex Communications Inc. 12000 Portland Ave South, Burnsville, MN 55337, USA
USA Phone: 1-800-392-3497, Fax: 1-800-955-6831
Canada Phone: 1-866-505-5551, Fax: 1-866-336-8467
Latin America Phone: 1-952-887-5532, Fax: 1-952-736-4212
©2004 TELEX COMMUNICATIONS, INC. SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. PA-20652 USA 6/04
A
D
G
E
H
F
I
C
B
J
K
L
M
In accordance with Federal Communications Commission (FCC) rules and regulations, Telex
SoundMate personal listening systems are intended only for use in providing auditory assistance to
the handicapped and are not intended for use by the general public.
* The last three digits in the transmitter catalog number (XXX) will be determined
by the frequency that is selected.
RECEIVERSTRANSMITTERS
ACCESSORIES
NOT SHOWN RM-S Single Rack Kit
RM-D Double Rack Kit
Power Requirements (2) AA batteries, Alkaline, NiMH or NICAD
30 hours Alkaline, 20 hours NiMH, 10 hours NICAD
Audio Frequency Response <3 dB Variation (100 Hz-10 KHz)
Sensitivity 0.5 µV typical, 1.0 µV maximum,12 dB SINAD
Signal-To-Noise @ 1 mV Input >60 dB
Distortion <2% T.H.D.
Audio Output @ 10% distortion into 8 Ohms: 2.0V / 15mW 3.0V / 80mV
into 32 Ohms: 2.0V / 10mW 3.0V / 50mW
Antenna Type omnidirectional in earphone cord
Controls Volume/On/Off Switch
Dimensions H 4” (101 mm) x W 2-3/4” (70 mm) x D 1” (25 mm)
Visual Indicators Red LED On Indicator
Earphone Connector Type 3.5 mm stereo or mono
Charger Contacts Bottom of unit
FCC Complies with Part 15