Sony SAVA-500 Speaker System User Manual


 
Troubleshooting
If you experience any of the
following difficulties while using
the speakers, use this
troubleshooting guide to help you
remedy the problem. Should any
problem persist, consult your
nearest Sony dealer.
Remote operations cannot be
performed.
•"_ Point the remote towards the
remote sensor [] on the left front
speaker
Remove any obstructions between
the remote and this system's left
front speaker.
"_'Replace the batteries in the
remote.
There's no sound from any of the
speakers.
Check that components are
connected securely to the
speakers.
Make sure you selected the correct
input (TV, VIDEO, AUX, or
5.1 CH IN).
Press MUTING to cancel the
muting function.
"_'Press MASTER VOL + to turn up
the volume.
•"_lf you are using the TV's
VARIABLE AUDIO OUTPUT
terminals, turn up the volume on
the TV to increase the output level.
No sound or only a very low sound
level is heard from the rear speakers.
"_Surround sound is turned off.
Adjust the volume of the rear
speakers (see page 11).
,,,_ Check the sound image balance
with T.TONE (see page 11).
There's no sound from the center
speaker.
-I_Make sure you selected the PRO
LOGIC or C.STUDIO surround
mode
m_'Set the Dolby Pro Logic Surround
center mode to any other mode
than PHANTOM.
Severe hum or noise is heard.
•"_ Make sure all connecting cords are
placed away from any
transformers or motors and least
10 feet (3 meters} from any
fluorescent lights
"_ Connect the speakers to your VCR
or cable box instead of to your TV.
15