Sony SA-NS400 Speaker User Manual


  Open as PDF
of 2
 
Sony
®
Wireless Network Speakers
Easy to set up. Easy to use.
PC or Mac, play music anywhere
your Wi-Fi
®
goes —even outside.
SA-NS300 SA-NS400 SA-NS500
STEP 1: Introduce your speaker to your router.
Before you begin, make sure your router and computer are on and connected.
1. Turn speaker on: 2. Connect speaker and computer to router.
When “LINK” light on speaker turns orange, unplug the
cable. System will reboot/sync to Wi-Fi
®
(
green light
)
.
SA-NS300, SA-NS400
On back near base.
Ethernet
Cable
(
included
)
Router/
Access Point
To
Computer
OPTION 1: Automatic Wired Set-up
(
easy 2-step method
)
1. Turn speaker on: 2. Press “WPS” button
on router:
3. Press/hold “WPS”
button
(
for 3 sec.
)
on back of speaker
When “LINK” light on speaker turns orange,
system will reboot/sync to Wi-Fi
®
(
green light
)
.
SA-NS300, SA-NS400
On back near base.
SA-NS500
(
2 buttons
)
On bottom.
Both buttons need to
be in the up position
for sync only.
SA-NS500
(
2 buttons
)
On bottom.
Both buttons need to
be in the up position
for sync only.
Router/Access Point
The WPS button may vary.
Check your router manual.
OPTION 2: “WPS” Push-button Set-up
(
Wi-Fi
®
Protected 3-step method
)
IMPORTANT NS500 ONLY: After connection is made, switch bottom button
down to NETWORK STANDBY MODE to play.
Additional set-up methods for any router, computer and most operating systems are detailed in the
operating instructions manual in the box. Also enclosed is a Quick-Start Guide for PC and Mac.