Sony RDP-X500IP Speaker User Manual


 
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings.
Install in accordance with the manufacturer’s
instructions.
8) Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
9) Do not defeat the safety purpose of the
polarized or grounding-type plug. A polarized
plug has two blades with one wider than the
other. A grounding type plug has two blades
and a third grounding prong. The wide blade
or the third prong are provided for your safety.
If the provided plug does not fit into your
outlet, consult an electrician for replacement
of the obsolete outlet.
10) Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit
from the apparatus.
11) Only use attachments/accessories specified by
the manufacturer.
12) Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use
caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms
or when unused for long periods of time.
14) Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen
into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate
normally, or has been dropped.
For the customers in Canada
This Class B digital apparatus complies with
Canadian ICES-003.
For the state of California USA only
Perchlorate Material –special handling may apply, see
www.dtsc.ca.gov/hazardouswaste/perchlorate
Perchlorate Material: Lithium battery contains
perchlorate
4-287-198-12(1)
©2011 Sony Corporation
Personal Audio Docking System
RDP-X500iP
Printed in China
Reference Guide
For USA customers only
NOTE
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment
and receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV
technician for help.
WARNING

Replace the battery for the remote commander
with a Sony CR2025 lithium battery only. Use
of another battery may present a risk of fire or
explosion.

Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.

Dispose of used battery promptly. Keep away
from children.

Keep the lithium battery out of the reach of
children. Should the battery be swallowed,
immediately consult a doctor.
English
Owner’s Record
The model number and the serial number are located on
the bottom.
Record the serial number in the space provided below.
Refer to them whenever you call upon your Sony dealer
regarding this product.
Model No. RDP-X500iP
Serial No. ________________________________
For customers in the USA
Please register this product on line at
http://www.sony.com/productregistration
Proper registration will enable us to send you
periodic mailings about new products, services,
and other important announcements. Registering
your product will also allow us to contact you
in the unlikely event that the product needs
adjustment or modification. Thank you.
WARNING
To reduce the risk of fire or electric
shock, do not expose this apparatus to
rain or moisture.
To reduce the risk of fire, do not cover the
ventilation opening of the apparatus with
newspapers, tablecloths, curtains, etc.
Do not place the naked flame sources such as
lighted candles on the apparatus.
To reduce the risk of fire or electric shock, do not
expose this apparatus to dripping or splashing,
and do not place objects filled with liquids, such
as vases, on the apparatus.
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
Do not expose batteries or apparatus with battery-
installed to excessive heat such as sunshine, fire or
the like.
As the main plug is used to disconnect the system
from the mains, connect the system to an easily
accessible AC outlet. Should you notice an
abnormality in the system, disconnect the main
plug from the AC outlet immediately.
The system is not disconnected from the mains as
long as it is connected to the AC outlet, even if the
system itself has been turned off.
The dating code and the nameplate are located on
the bottom exterior.
CAUTION
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same type.
Remote commander
Before using the supplied remote commander for
the first time, remove the insulation film.
Aim the remote commander at the front of the
unit near the remote sensor
.
The
Reaction indicator flashes when the
remote commander’s command is received.
VOL + and buttons have a tactile dot.
/ (Power)

Turn the unit on/off. The / indicator lights
up when the unit is turned on.
(Play/Pause)

Start playing iPod. Press again to pause/resume
playback.

Press and hold to turn off the iPod.
(Forward)

Go to the next track.

Press and hold while listening to the sound to
locate a desired point.

Press and hold in pause while observing the
display on iPod to locate a desired point.
(Backward)

Go back to the previous track. During
playback, this operation returns to the
beginning of the current track. To go back to
the previous track, press twice.

Press and hold while listening to the sound to
locate a desired point.

Press and hold in pause while observing the
display on iPod to locate a desired point.
(Up)/ (Down)

Select a menu item or track for playback.
iPod

Select iPod as source.
AUDIO IN

Select AUDIO IN as source.
MENU

Go back to the previous menu.
ENTER

Execute the selected menu item or begin
playback.
VOL +/− (Volume plus/minus)

Adjust the volume.
Note

The iPod nano (6th generation) cannot be
controlled by the remote when the command of
MENU,” “,” “,” and “ENTER” is pressed.
When to replace the battery
With normal use, the battery (CR2025) should
last for about 6 months. When the remote
commander no longer operates the unit, replace
the battery with a new one.
the side facing up
Note

If you are not going to use the remote
commander for a long time, remove the battery
to avoid any damage that may be caused by
leakage and corrosion.
Precautions

To disconnect the AC adaptor, pull it out by the
plug, not the cord.

Since a strong magnet is used for the speaker,
keep credit cards using magnetic coding or
spring-wound watches, CRT-based TVs, or
projectors, etc., away from the unit to prevent
possible damage from the magnet.

Do not leave the unit in a location near a heat
source such as a radiator or airduct, or in a
place subject to direct sunlight, excessive dust,
mechanical vibration, or shock.

Allow adequate air circulation to prevent
internal heat build-up. Do not place the unit on
a surface (a rug, a blanket, etc.) or near
materials (a curtain) which might block the
ventilation holes.

Should any solid object or liquid fall into the
unit, unplug the unit and have it checked by
qualified personnel before operating it any
further.

Do not handle the unit with wet hands.

Do not place the unit anywhere near water.
NOTES ON LITHIUM BATTERY

Wipe the battery with a dry cloth to assure a
good contact.

Be sure to observe the correct polarity when
installing the battery.

Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
Note

In the Reference Guide, “iPod” is used as a
general reference to functions on an iPod,
iPhone or iPad, unless otherwise specified by
the text or illustrations.
If you have any questions or problems concerning
your unit, please consult your nearest Sony dealer.
Operations
Power source
Power management system
After playback of the iPod (or component
connected to
AUDIO IN jack) has finished, if no
operation is performed for about 20 minutes, the
unit will automatically turn off.
To prepare a power source
Connect the supplied AC adaptor to the DC IN
19.5V jack on the back of this unit firmly, and
plug it into a wall outlet.
Note on the AC adaptor

Use the supplied Sony AC adaptor only. The
polarity of the plugs of other manufacturers
may be different. Failure to use the supplied AC
adaptor may cause the unit to malfunction.
To charge your iPod
You can use the unit as a battery charger for your
iPod when the power is supplied by the AC
adaptor.
Charging begins when the iPod is connected to
the unit. The charging status appears in the
display on iPod. For details, see the user’s guide of
your iPod.
Note

The iPod continues to be charged when
powered by the AC adaptor and turned on or
off.
To turn the unit on/off
Press / (power).
The
/ indicator will light up when the unit is
turned on.
To adjust the volume
Press VOLUME +/−.
To select iPod or AUDIO IN as
the source
Press iPod or AUDIO IN.
The iPod or AUDIO IN indicator will light up
when the button is pressed.
To play/pause the iPod
Press .
The Reaction indicator flashes when the
command is received.
Reaction indicator
Remote sensor
Docking Tray
Indicator
C
M
Y
CM
MY
CY
CMY
K
app_store_logo.ai 2011/04/25 10:24:59